Ametek Powervar ABCE1002-11R 58100-01R, Instruction Manual

Page: 59 / 66

59 A01-00071 Rev F www.powervar.com
A03-00435 - Rev. D 2 www.powervar.com
Front Panel Controls
 Power On/Off
 Test
 Load Level LED Gauge

Battery Charge LED Gauge

Voltage Manager Boost LED

Voltage Output On LED

Voltage Manager Buck LED

On Battery LED

Replace Battery LED

Overload LED

Fault Code LED

System Over Temperature LED
Rear Panel Information and Controls

1.8 Meter Power Cord with C20 to C19 IEC300

Configuration Manager DIP Switches

Communications Manager DB9 Port, USB Port

Circuit Breaker

AC Inlet Module

SNMP Slot (Contact Factory)
Internal Batteries
 User Hot-Swappable (See Instruction Manual)
 Type: 12 Volt, High Rate 23W
 Quantity: 8 Batteries

Recharge Time: 8 Hours to 80%, 24 Hours to Full Charge
Environmental

Temperature: 0 - +40
0
C (32 to 104
0
F) Operating
-20 to 60
0
C (-40 to 140
0
F) Shipment/
Storage

Humidity: 5 to 90% Non-Condensing (Operating,
Shipment/Storage)

Altitude: 3,000m (10,000 ft) max. Operating;
12,000m (40,000 ft) max. Shipment/Storage.
Safety Agency and EMC Compliance:
All Units are Listed by UL and Marked with the UL/cUL Marking.
Standard UPM:
Products Listed To:

UL IEC62040, CE Mark with CB Report
Products in compliance with:

FCC-Part 15, Subpart B, Sections 15.107b & 15.109b
Class A Digital Device*

CISPR11:2009, A1; 2010, Class A*

IEC61000-4-2, Electrostatic Discharge

IEC61000-4-3, Radiated Electromagnetic Field Immunity

IEC61000-4-4, Electrical Fast Transient/Burst Immunity

IEC61000-4-5, Surge Immunity

IEC61000-4-6, Immunity to Conducted Radio Frequency
Disturbances

IEC61000-4-8, Power Frequency Magnetic Field Immunity

IEC61000-4-11, Voltage Dips, Short Interruptions, and
Voltage Variations
*Note: Class B is Available as an Option
Please Consult Your Powervar Sales Representative
RoHS Compliance:
All Products (Standard and Medical) are RoHS Compliant
2200VA TYPICAL RUN-TIMES (MINs)
10% (198W) 20% (396W) 30% (594W) 40% (792W) 50% (990W) 60% (1188W) 70% (1386W) 80% (1584W) 90% (1782W)
100%
(1980W)
Internal Batteries Only 95 45 30 19 14 10.5 8 6.5 5.5 4.5
In 1) E4804-12 281 135 85 59 42 32.5 23 19 14.5 12
In 2) E4804-12 467 225 140 99 70 54.5 38 31.5 23.5 19.5
In 3) E4804-12 653 315 195 139 98 76.5 53 44 32.5 27
In 4) E4804-12 839 405 250 179 126 98.5 68 56.5 41.5 34.5
In 5) E4804-12 1025 495 305 219 154 120.5 83 69 50.5 42
In 6) E4804-12 1211 585 360 259 182 142.5 98 81.5 59.5 49.5
In 7) E4804-12 1397 675 415 299 210 164.5 113 94 68.5 57
In 8) E4804-12 1583 765 470 339 238 186.5 128 106.5 77.5 64.5
NOISE REJECTION-ISOLATION: With unit under power and an ANSI/IEEE C62.41Cat. A pulse applied either normal or common mode
at the input, the noise output voltage will be less than 10V normal mode and less than 0.5V common mode in all four quadrants (CM-NM, NM-
NM, CM-CM, NM-COM).
SURGE VOLTAGE WITHSTAND CAPABILITY: Tested under power to ANSI/IEEE C62.41 Cat. A & B (formerly IEEE587-1980). Cat. A -
6000V @ 200 amps, 0.5 usec risetime, 100 kHZ decay, Cat. B - 6000V @ 500 amps, 0.5 usec risetime, 100 kHZ decay.
Warranty/Support: POWERVAR warrants the electronics and transformers used in its uninterruptible power managers to be free from
defects in materials and workmanship for a period of five years from the date of shipment. Batteries are warranted for a period of two years from
the date of shipment. For service or support on any POWERVAR product, please contact POWERVAR Technical Support at (800) 369-7179 or
visit the POWERVAR website at ww.powervar.com .
Battery Life Disclaimer : POWERVAR’s standard battery warranty applies only to UPS and UPM products which are continuously connected to
AC mains power, except during utility power outages. Products which are regularly and intentionally disconnected from AC mains power will
experience battery discharge/charge cycles potentially far more numerous than those for which the battery was designed. As a result, products
used in such applications will experience substantially reduced battery life. For that reason, POWERVAR’s standard battery warranty does not
apply for applications in which the UPS or UPM product is regularly and intentionally disconnected from AC mains power. POWERVAR UPS and
UPM products used in such applications shall receive a 90 day warranty on batteries.
Security II UPM Specifications
International Models ABCE2202-22R