TOOLS REQUIRED; Fig. 2
Fig. 2
1 Channel Locks
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
4 Phillips Screwdriver
5 Flat Blade Screwdriver
6 Electric Drill & 1/4" Drill Bit
7 Tape Measure
1
2
3
4
5
6
7
2
10'
Fig. 1
114mm
(4-1/2)
500mm
(20")
1524mm
(60)
381mm
(15)
3/8" COMP.
131mm
(5-1/8)
32mm (1-1/4)
125mm
(4-7/8)
81mm
(3-3/16)
49mm
(2)
141mm
(5-1/2)
11-1/8"
(284mm)
6-1/8"
(155mm)
MOUNTING
SURFACE
381mm
(15)
49mm
(2)
Roughing-in Dimensions
7"
(179mm)
GENERAL DESCRIPTION:
Electronic faucet with proximity operation. Vandal resistant solid brass
construction single post mounting. Operates on DC (battery) or AC
permanent power. In-line strainer for solenoid is integral. Single inlet 3/8
compression, built-in checks, and flexible stainless steel 15" reach inlet hose
for spout connection.
M 9 6 8 8 0 9
Rev. 1. 7
CAUTION: Use only American Standard
supplied cable sets. Using non-AS
supplied cables, or cutting, splicing or
modifying any components will void the
warranty.
Note: All plumbing and electrical wiring must be installed in accordance with
applicable codes, regulations and standards.
INSTALL SPOUT ASSEMBLY;
Fig. 1
INSTALLATION
CAUTION
Turn off hot and cold water
supplies before beginning
1
1. (Optional) Assemble DECK PLATE (1) and PUTTY
PLATE
(2) to FAUCET BODY (3) with SCREW (4). Fig.1.
2. Connect the two 27" EXTENSION CABLES (5) to
the Faucet Sensor Cables.
Fig. 1.
3. Insert 27" EXTENSION CABLES (5) , FLEX HOSE
(6) and SPOUT SHANK (7) through center hole of
mounting surface.
Fig. 1a.
4. Assemble "C" WASHER (8) and LOCKNUT (10)
onto threads of SPOUT SHANK
(7) from underside of
mounting surface.
Fig. 1b.
5. Align FAUCET (3) and tighten LOCKNUT (10). If
using DECK PLATE
(1) hand tighten DECK PLATE
SPIN NUTS
(11) to secure FAUCET (3) to mounting
surface.
Fig. 1b.
10
11
Fig. 1a
Fig. 1b
5
7
7
6
8
3
1
1
2
2
Fig. 1
4
5
SENSOR
CABLES
