754749-100 Rev. C
CURVED APRON TUB
HIGH GLOSS ACRYLIC SURFACE
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN....
Local building codes vary by location. Observe all local plumbing and building codes.
Your new bath is shipped to you after careful inspection. All you need to finish the installation are your selected fittings.
To ensure maximum performance and pleasure from this product, please follow the instructions and cautions.
TOOLS & MATERIALS REQUIRED....
NOTE: Take extra care in handling surfaces of the bath. Use only non-abrasive cloths to avoid scratching.
• Level
• Square
• Tape Measure
• Pipe Wrench
• Slip Joint Pliers
• Nails
• Plumber’s Putty
• Silicone Sealant
• 1 x 3 or 2 x 4 Stringers
• Drop Cloth
• Mortar Mix or Grout
TOOLS:
• Screw Driver
• Standard Woodworking Tools
• Personal Safety Equipment
• Caulking Gun
MATERIALS:
MODEL: 2647 SERIES
Visit
www.americanstandard.com for coordinating products.
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
© A S A m e r i c a , I n c . 2 0 1 3
GENERAL INSTALLATION INFORMATION ...
1. When installing the coordinting bath walls (3060BW Series for example), additional studs may be
required. Refer to those installation instructions prior to installing tub.
2. Bath walls are to be installed over stud walls.
3. Bath may only be installed in a recess type installation.
4. It is recommended that the tub be set in a small bed of mortar or grout to compensate for uneven floors.
Stringers will help level tub but will not provide adequate support.
5. Take extra care when driving nails or screw to avoid damaging the bath.
