GAS WALL OVENS
PROBLEM
POSSIBLE CAUSE
WHAT TO DO
Oven will not heat
No electrical power to the range
Gas service is turned off
Gas supply has been interrupted
Look for red glow of hot surface igniter
Check circuit breakers in house
Contact the gas company
If no glow, call for service
Oven light does not
work
Light switch is in the off position
Light is burned out
Try switching the light on
Locate and test a new replacement light, unscrew glass
lens, remove bad light, replace
Broiler will not light
No electrical power to the range
Gas service is turned off
Look for red glow of hot surface igniter
Check circuit breakers in house
If no glow, call for service
Convection fan does
not turn
Switch the fan on
Unit in broil mode
Bad fan
Adjust oven selector switch to Convection.
Turn thermostat to bake temperatures.
Call for service
Condensation on the
oven window
Cold appliance
It is normal for some condensation to appear on the
window; it will disappear in about ten minutes.
Foods over-cook
Incorrect temperature cooking time, or rack
position. Temperature differs from your previous
oven.
Oven not pre-heated
Reduce cooking time, or temperature. This modern
appliance operates at the set temperature. You may want
to reduce the set temperature until you become more
familiar with your new oven.
Allow pre-heat cycle to complete.
Foods under-cook
Incorrect temperature, cooking time or rack position Adjust accordingly
Baked goods dark on
bottom
Dark colored cookie sheets
Use light-colored cookie sheets
22
4580 N. Walnut Rd., N. Las Vegas, NV 89081 | 13592 Desmond St., Pacoima, CA 91331 | tel: 818.897.0808 | 888.753.9898 | www.AmericanRangeHome.com
© 2022 American Range All Rights Reserved
CARE AND CLEANING RECOMMENDATIONS
PART / MATERIAL
CLEANING SUGGESTIONS
BEING CAREFUL
Control Knobs/
Powder Paint
Use dry hands to pull off the knobs; hot sudsy water works
best here…
…with a sponge to avoid scratching
Chrome Knob Bezels
Hot soapy water works well here, with a sponge or soft
cloth.
As with any round feature that meets the stainless steel grain,
be careful to clean the bezels in a circular motion – and not
contact the stainless steel control panel.
Exterior Finish
Use hot soapy water, Fantastic, Formula 409, rinse and dry
immediately. For hard water spots, try household vinegar or
CLR. If there is any heat discoloration, consider using Zud,
Wright’s All Purpose Polish or Blue Away.
Rub lightly in the direction of the grain of the stainless steel.
Salt (sodium chloride), chlorine or chlorine compounds in
some cleaners are corrosive to stainless steel.
USE AND CARE
TROUBLESHOOTING GUIDE
