Owner’s Manual
Countertop Fryer
13592 Desmond St., Pacoima, CA 91331 818.897.0808 tel 888.753.9898 toll free www.americanrange.com
3
• Before beginning, please read all the instructions carefully.
• DO NOT remove permanently affixed labels, warnings, or plates from product. This will void the warranty.
• All local and national codes and ordinances must be observed; installation must conform with local codes.
• The Installer must leave these instructions with the consumer who should retain for local inspector’s use and for future reference.
• Installation and service must be performed by a certified / licensed installer, service agency or gas supplier.
Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your
appliance. Always read and obey all safety messages.
IMPORtANt - PLEASE READ AND FOLLOW!
RAtING PLAtE -
The location of
the rating plate is shown in
Figure 1
.
The information on the rating plate
defines the model, serial number,
gas type (natural or liquid propane),
operating pressures and burner BTU
ratings. Keep this information for
future reference. It is essential for
proper identification of the unit when
requesting additional information or
factory support.
Appliances must be connected
only to the type of gas identified
on the rating plate.
WARNING
!
3013256
MODEL:
SERIAL NO.
AFCT-15
999999-CO9999
GAS TYPE: NAT
TANK ID#2
MAN. PRESS:
IN. W.C.
4.0
INPUT-BTU/HOUR/BURNER
CLEARANCES
NON-COMB. COMB.
30,000
BACK
SIDES
0”
0”
6”
6”
SUITABLE FOR INSTALLATION ON COMBUSTIBLE FLOORS
USING 6” ADJ. LEGS OR CASTERS.
INTENDED FOR OTHER THAN HOUSEHOLD USE.
ANSI Z83.11a/CSA 1.8a-2007 Food Service Equipment
RATING PLATE
Figure 1
cLEARANcES -
The appliance must be kept free and clear of all combustible materials.
This unit is designed and certified for the following installation only:
cLEARANcES
NON-COMBUSTIBLE
COMBUSTIBLE
Sides
0"
6"
Rear
0"
6"
Floor
0"
6"
Installation on
non-combustible floor shall
be with factory supplied
legs or casters.
SHIPPING DAMAGE cLAIM PROcEDURE
The equipment is crafted and inspected carefully by skilled personnel before leaving the factory. The transportation company
assumes full responsibility for the safe delivery upon acceptance of the equipment.
If you receive a damaged product, immediately contact your delivery company, your dealer, your builder or installer. Do not
install or attempt to operate a damaged appliance.
1. Note any visible loss or damage on the freight bill or express delivery and have the note signed by the person making
the delivery.
2. File claim for damages immediately regardless of the extent of damages.
3. For damage noticed after unpacking (concealed loss or damage), notify the transportation company immediately and file
a “Concealed Damage” claim with them. This should be done within fifteen (15) days from the date that delivery
is made to you. Retain the shipping container for inspection.
Rating Plate
