OWNER’S MANUAL
INSTALLATION
Q U A L I T Y P R O F E S S I O N A L C O O K I N G E Q U I P M E N T
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
NOTICE
!
NOTICE
!
NOTICE
!
NOTICE
!
NOTICE
!
NOTICE
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
The appliance is NOT jet stream approved. DO NOT clean the appliance with a
water jet.
DO NOT use an open flame to check for gas leaks!
Installation must conform with local codes, or in the absence of local codes, with
the National Fuel Gas Code. ANSI Z223.1, National Gas Installation Code. CAN/
CGA-B149.1, or the Propane Installation Code, CAN/CGA-B149.2, CE Gas
Appliance Directive’s 2009/142/EC (ex-90/396/EEC) Annex II, AU AS/NZS 5601,
as applicable.
Post in a prominent location the instructions to be followed in the event that
an operator smells gas. Obtain this information from your local gas supplier.
Installation and servicing of the equipment should be performed by authorized
personnel only and to AS/NZS 5601.
Completely shut the appliance down when shortening /oil is being drained from the
appliance. This will prevent the appliance from heating up during the draining and
filing process. Serious injury can occur.
The appliance is intended for indoor use only.
There is an open flame inside the appliance. The unit may get hot enough to set
nearby materials on fire. Keep the area around the appliance free from combustibles.
• Hot oil and hot surfaces can cause sever burns. Use caution when operating the fryer.
• Do not attempt to move the fryer when filled with hot oil or shortening
• Drain hot oil into metal containers. Do not use plastic buckets or glass containers.
• Do not operate this unit without oil in vessel.
• Do not stand on fryer to clean overhead equipment.
• Do not go near the area directly above the flue when the fryer is in operation. Sever
burns may be caused.
When this appliance is installed with casters, it must be installed with the casters
supplied, a connector complying with either ANSI Z21.69 CSA 6.16 and a quick-
disconnect device complying with ANSI Z21.41 CSA 6.9. It must also be installed with
restraining means to guard against transmission of strain to the connector, as specified
in the appliance manufacturer instructions. CE Gas Appliance Directive’s 2009/142/EC
(ex-90/396/EEC) Annex II, AU AS/NZS 5601, as applicable.
These installations procedures must be followed by qualified personnel or warranty will
be void. Local codes regarding installation vary greatly from one area to another. The
National Fire Protection Association, Inc. States in its NFPA 96 latest edition that local
codes are the “authority having jurisdiction” when it comes to installation requirements
for equipment.
Ensure the appliance can get enough air to keep the flame burning correctly. If the
flame is starved for air it can give off a dangerous carbon monoxide gas. Carbon
Monoxide is a clear odorless gas that can cause suffocation.
Never add water to hot oil. Violent boiling can occur causing severe injury
Never add oil to the appliance when it is at operation temperature. Splashing hot
oil can cause severe injuries.
This appliance is intended for professional use only and should be operated by
fully trained and qualified personnel.
If disconnection of the restraint is necessary to move the appliance for cleaning
etc., reconnect it when the appliance is moved to its original installed position
Units must be level to assure maximum performance. Improper leveling may void
warranty.
All gas appliances vented through a ventilation hood or exhaust system with a
damper or with a power means of exhaust shall comply AV AS/NZS 5601.
3
13592 Desmond St. Pacoima CA 91331
Tel: 818.897.0808
www.americanrange.com
Imported by Tom Stoddart Pty Ltd
1300 79 1954
www.stoddart.com.au