LIGHTING AND OPERATION OF SAFETY PILOT KITS
IMPORTANT! CHIMNEY DAMPER MUST BE WIDE OPEN! THE FLUE MUST VENT ALL PRODUCTS OF
COMBUSTION. DAMPER AND GLASS DOORS MUST BE FULLY OPEN BEFORE LIGHTING OR
BURNING FOR PROPER VENTILATION AND TO PREVENT HEAT DAMAGE TO THE VAVLE.
PILOT LIGHTING INSTRUCTIONS
1. Turn
VALVE KNOB
to
“PILOT”
position.
2. Depress and hold until air is bled and gas flows to Pilot .
3. Light Pilot with a Match or Lighter.
4. Once Pilot is lit, continue to depress and hold until the Pilot
flame remains lit (approximately 30 to 60 seconds).
5. If Pilot does not remain lit, depress and turn Valve Knob
clockwise to
“OFF”
position and wait at least 5 minutes to
allow gas to dissipate. Repeat steps 1 thru 4.
SAFETY MANUAL CONTROL VALVE SKP-N/P-M
ON/OFF SOLENOID
VALVE KNOB
PILOT ADJUMENT
SCREW
KNOB CONTROL INDICATOR
WARNING! DO NOT OPERATE BURNER
WITH VALVE HEAT SHIELD.
VALVE PLUG
1. Turn
VALVE KNOB
counter clockwise to “ON” position
2. Adjust the burner flame height by turning the valve knob
clockwise to lower and counter-clockwise to raise up to full on.
FULL ON
IMPORTANT INFORMATION ON YOUR VALVE GAS CONTROL
It is intended to prevent premature valve failure and voiding of warranty.
Replace immediately if removed for any reason.
The “EASY Safety Control Valve must be protected to a maximum ambi-
ent temperature of 225° F. Excessive heat to the valve is indicated by
melted plastic or wiring on the valve body and is not warrantable.
Allow an adequate period of cooling after use before closing glass doors.
NEVER operate your BURNER with glass doors closed.
LOWER OR
PILOT POSITION
SAFETY ON / OFF CONTROL VALVE SKP-N/P-O
BURNER OPERATION FOR ON / OFF
1. See above instructions on Pilot Lighting Instructions
2. Turn
VALVE KNOB
to “ON” position.
(See Knob Operation)
3. Slide switch on the
RECEIVER
to
“REMOTE”
position.
4. Consult Operating Instructions for Accessory Control.
5. Adjust the burner flame height by turning the valve knob
clockwise to lower and counter-clockwise to raise up to full on.
RECEIVER SLIDE
SWITCH IN “REMOTE”
POSITION
THE RECEIVER HAS 3
POSITIONS; “OFF”,
“FULL ON” AND
“REMOTE ACCESS ON”
DC POWER FROM THE RECEIVER OPERATES THIS UNIT.
DO NOT CONNECT TO A 115V AC LINE.
Note:Consult Operating Instructions for Accessory Control.
KNOB OPERATION
7.
