OUTDOOR DOME INSTALLATION
SPEEDDOME ULTRA
3-4
Mounting the Dome’s Base in
the Outdoor SpeedDome
Housing
The following procedure explains how to use an
adapter bracket to mount the dome’s base in an
existing outdoor SpeedDome housing. After com-
pleting this procedure, go to page 3-5 for dome
setup and attachment procedures.
New installations.
If installing the
SpeedDome housing as a “new” unit, see
the installation instructions suplied with the
housing and outdoor mounts, then perform
this procedure.
Tool Required
Phillips head screwdriver
Mounting Structure and Install Kit Required
RHSDA Adapter Bracket*
a. Adapter bracket assembly
1
0400-0868-01
* Only part used in this procedure is listed.
SpeedDome Ultra Install Kit 0351-1109-01
b. Screw, PH, M3x
6
5801-1051-120
*
Only part used in this procedure is listed.
Procedure
If installing a new outdoor housing, begin the
procedure at step 4.
1. Squeeze the spring-loaded ejector pins
together to drop the old SpeedDome chassis
from the outdoor housing.
2. Detach video and data/power cables from
the old SpeedDome.
3. Find the data/power cable from the outdoor
interface board. Remove the connector from
this cable.
4. Mount the SpeedDome Ultra camera dome’s
base to the adapter bracket [a] (Figure 3-2).
Use two of six screws [e] to attach the base to the
bracket. Tighten screws to secure.
Figure 3-2. Attaching the mounting base to the
adapter bracket
2. Feed cables as shown, then attach the
adapter bracket to the outdoor SpeedDome
housing (Figure 3-3).
a. Seat the ball of the lanyard hanging from the
adapter bracket into the bracket at the top of the
housing.
b. Squeeze the spring-loaded ejector pins together
to seat the adapter bracket in the corner
receptacles of the housing.
Figure 3-3. Attaching the adapter bracket to the
outdoor SpeedDome housing
a
b
Ejector Pins