SERVICE
SPEEDDOME ULTRA
4-8
How to Remove the Camera
1. Perform the procedure “How to Remove the
Slot Covers” (page 4-7).
2. Remove the ribbon cable from the camera
(Figure 4-9).
Swivel the camera yoke to expose the camera
connector. Then, using a small slotted screwdriver,
1) “gently” pry the camera connector loose from the
camera and 2) pull it down through the cable tie
wrap.
Figure 4-9.
2
1
3. Remove the camera (Figure 4-10).
1)
Loosen the screw holding the camera tripod
mount, then 2) carefully lift the camera out.
Figure 4-10.
1
2
Reverse steps to reassemble. Ensure that ribbon
cable pins are inserted “face down”.
How to Detach the Eyeball
1. Perform the procedure “How to Remove the
Slot Covers” (page 4-7).
2. Perform the procedure “How to Remove the
Camera” (this page).
3. Detach the eyeball from the housing (Figure
4-11).
To do this, turn the yoke to access tabs [a]. One tab
will be more accessable than the other. Use your
finger to press this tab while, simultaneously, using a
small slotted screwdriver to press the other. While
pressing the tabs, push up on the eyeball [b] to
detach it.
Figure 4-11.
a
b
4. Detach the slip ring connector (Figure 4-12).
Figure 4-12.
