MEGAPOWER CPU
8200-0421-03, REV. G
ADMINISTRATOR’S GUIDE
11 of 82
○
Dual MPCPU:
Enter
100
for the selected
MegaPower CPU, or enter
101
for the
Standby MP CPU.
d. Press the
Ack
key located in the lower right
corner.
The System Menu appears on the LCD screen
(Figure 12).
Note:
To exit the LCD Menu Mode, press the
Menu
key.
Figure 12. System Menu screen
3. Press
Enter
to choose Addressing. The Address
Menu screen appears.
Figure 13. Address Menu screen
4. Press
Enter
to choose IP Address. The IP
Address screen appears.
Figure 14. IP Address screen
5. Scroll down to Set IP Addr and press
Enter
. The
Set IP Address screen appears.
Figure 15. Set IP Address screen
6. Scroll down to DHCP and press
Enter
. The
DHCP Setting screen appears.
Figure 16. DHCP Setting screen
7. Press
Enter
to choose Enable.
8. Exit from the MegaPower CPU menu system.
Using a Static IP Address
To set up the MegaPower CPU for a static IP
address:
1. Connect a keyboard to an RS-232 port on the
MegaPower CPU. Ensure the baud rates match
for the keyboard and CPU port in use.
2. Use the following instructions to provide the key
sequences for each supported keyboard:
AD2088
:
a. Place the keyboard in Menu Mode by turning
the keyswitch to
MENU.
The CAMERA LEDs
on the keyboard display
P6
.
b. Enter one of the following number sequences
for your MegaPower CPU installation:
○
Standalone MPCPU
: Enter
100
.
○
Dual MPCPU:
Enter
100
for the selected
MegaPower CPU, or enter
101
for the
Standby MP CPU.
c. Press the
ENTER
key, which is located above
the joystick. “ENTER” is stenciled on the front
face of the key; the top of the key may be
labeled either PRESET or SHOT.
The CAMERA LEDs on the keyboard will only
display
7P
if the selected CPU is accessed.
ADCC1100
:
a. Place the keyboard in Program Mode by
pressing its softkey.
Note
: To display and enter Program Mode, you
must insert a Smartcard that has administrator
privileges.
b. Press the
Matrix Menus
softkey.
c. Enter one of the following number sequences
for your MegaPower CPU installation:
○
Standalone MPCPU
: Enter
100
.
○
Dual MPCPU:
Enter
100
for the selected
MegaPower CPU, or enter
101
for the
Standby MP CPU.
d. Press the
Enter
softkey.
ADCC0200/0300
:
Notes
: In RS–232 mode, the ADCC0200
keyboard does not have matrix menu access
Summary of Contents for MegaPower ADMPCPU
Page 1: ...8200 0421 03 G MegaPower CPU ADMPCPU Administrator s Guide...
Page 2: ......
Page 85: ......
