American Dynamics ADODHCL, Installation And Service Manual, Page: 1 / 20

Installation and Service Guide
8000-2616-04, Rev. B (20 pages)
AD DeltaDome Outdoor Housing 1
1
AD DeltaDome
Outdoor Housing
ADODHCL with Clear Bubble
ADODHSM with Smoked Bubble
Figure 1
Parts Supplied
•
Housing assembly
•
Bubble assembly
•
Tamperproof drive (supplied with bubble)
•
Install kit 0351-1519-01
Purchase or Supply Separately
•
Plumber’s Teflon tape
•
Male BNC connector
•
Power, data, and alarm cables
Tools Required
•
1/4" fixed-handle nut driver for Torx bit
•
Wire cutters and strippers
•
Razor blade or scissors
•
3mm Allen wrench (supplied)
•
1-1/8" open-ended wrench
Contents
About the Outdoor Housing................................... 2
Data Cable Requirements ..................................... 2
Power Cable Requirements .................................. 2
Power-Up Routine ................................................. 2
Synchronizing Domes............................................ 2
Warnings and Cautions......................................... 3
Procedure.............................................................. 5
Preparing the Housing for Attachment............... 5
Attaching the Housing to the
Outdoor Mounting Structure............................... 6
PC Board Setup ................................................. 8
Attaching the Housing and
Eyeball Assembly............................................. 10
Attaching the Trim Ring/
Bubble Assembly ............................................. 12
Securing the Outdoor Housing
to Mounting Structure....................................... 12
Troubleshooting Outdoor Domes ........................ 13
Ordering Parts ..................................................... 16
Specifications ...................................................... 18
Declarations ........................................................ 18
About this Guide
This guide explains how to install ADODHCL and
ADODHSM outdoor housings. It does not explain
how to install the outdoor mounting structure to
which the housing is attached. For this information,
see information shipped with the structure.
DeltaDome, American Dynamics , and the AD logo are
trademarks of American Dynamics Corporation. Other
product names (if any) mentioned herein may be trademarks
or registered trademarks of other companies.
No part of this guide may be reproduced in any form without
written permission from American Dynamics Corporation.
© Copyright 1998. All rights reserved.
MDR 9/98
Bubble
Assembly
Mounting
Structure
Housing
Assembly