4-6
Operator's Manual
Displaying the Firmware Version
Firmware is the computer instructions programmed into the T
OUCH
T
RACKER
. It is unlikely that you will ever need to know the firmware version
of your T
OUCH
T
RACKER
. However, if you should experience a problem with
your T
OUCH
T
RACKER
, you may need to provide information about the
firmware version.
To display the firmware version of the T
OUCH
T
RACKER
, do the following:
1.
Use the number buttons to type
100
; then press
F1
.
Firmware information will appear on the LCD.
F 0701-2940-0100
E 0701-2941-0100
Information appearing after the “F” is the Flash version.
Information appearing after the “E” is the EEPROM version.
2.
Press
LCD Clear
to refresh the LCD display.
Setting the Baud Rate
The T
OUCH
T
RACKER
supports four baud rates: 1200, 2400, 4800, and 9600
baud. The default setting for the baud rate is 1200.
NOTE
If you set the baud rate incorrectly, the T
OUCH
T
RACKER
will not operate.
Be sure that you set the baud rate to the correct value.
Use the following procedure to set or change the baud rate.
1.
Use the number buttons to type the baud rate (1200, 2400, 4800 or
9600).
2.
Press
F1
(located to left of the LCD).
No prompts appear on the screen to inform you that the baud rate has been
changed.
