American Dream Ultra Performance Geothermal Copper Series, Installation And Service Manual

Page: 25 / 60

25 MAY 2009 Page 25 000744MAN-02
Startup Record (Air)—2-5 Ton Two-Stage R410a
Installation Site Startup Date
Installer
City Company
Province Model
Country Serial #
Check boxes unless asked to record data. Circle data units.
PRE-START INSPECTION
Ductwork Ductwork is completed, dampers/ diverters are adjusted
Registers are open and clear of objects
Air filter and end cap are installed
Condensate Drain is connected, properly vented and free of debris
Plenum heater is securely fastened (if applicable)
Line Sets
Connected to proper ports, insulated and secured in place
Domestic Hot All shut-off valves are open
Water Lines are full and purged
Desuperheater pump wire is disconnected
Electrical High voltage connections are correct and securely fastened
Circuit breaker (or fuse) size and wire gauge for Heat Pump A Ga.
Circuit breaker (or fuse) size, wire gauge, and Plenum Heater size A Ga. kW
Low voltage connections are correct and securely fastened
Unit Charge
Refrigerant charge be fore power is turned on Lbs kg
STARTUP DATA
Preparation Voltage across L1 and L2, L1 and L3, L2 and L3 VAC
Final refrigerant charge Lbs kg
Heating Mode Suction Discharge V1 S1 V2 S2 V3 S3 V4 S4 V5 S5 V6 S6
10 minutes
15 minutes ° F
20 minutes ° C
25 minutes
30 minutes
Average
Duct Return, Duct Supply, and Delta T In Out ° F ° C
Compressor L1 (black wire) current A
Domestic Hot Water functioning
Thermostat setpoint and discharge pressure at cycle end ° F ° C psig kPa
Cooling Mode
Suction Pressure / Discharge Pressure psig kPa
Duct Return, Indoor Out, and Delta T In Out ° F ° C
Thermostat setpoint and suction pressure at cycle end ° F ° C psig kPa