ADJ Products, LLC www.adj.com - WiFly WLC16 Page 8
ADJ Products, LLC www.adj.com - WiFly WLC16 Page 9
1. DC INPUT - Accepts a DC12V, 500mA minimum, power supply.
2. POWER SWITCH - Use this switch to power on/off the controller.
3. DMX OUT - Used to send DMX signal to the compatable LED fixtures.
4. WIFLY DMX ON/OFF SWITCH - Use this switch to power on/off the
WiFly wireless DMX.
WiFly WLC16
Controls and Functions - Rear Panel
WiFly WLC16
Controls and Functions
1. ANTENNA - This is used to send WiFly wireless DMX signal.
2. SCENE SELECTION - Press the scene buttons to load or store your
desired scenes. There are a maximum of 480 programmable scenes.
3. FIXTURE SELECTION - Press the fixture buttons to turn the fader con-
trol on/off for the corresponding channels.
Example: Press the Fixture 1 button to turn the 1-32 channel fader con-
trols on. Press the Fixture 1 button again to turn off the fader controls of
channels 1-32. Press the Fixture 2 button to turn the 33-64 channel fader
controls on. Press the Fixture 2 button again to turn off the fader controls of
channels 33-64.
4. PAGE SELECT BUTTON - This button is used to switch between page
A (1-16) and page B (17-32).
5. CHANNEL FADERS - These faders are used to control channels 1-16 or
17-32 depending on the selected page.
6. SD CARD SLOT - Insert a SD card into this slot to record date from the
controller.
7. ADD BUTTON - Press this button to store a scena or chase.
8. DELETE BUTTON - This button is used to delete a scene or chase.
9. AUTO BUTTON - This button is used to activate auto mode to run a
scene or chase.
10. Tap Sync BUTTON - Repeatedly Press this button to set the chase
speed or check the Step in the chase.
11. SPEED FADER - This fader is used to adjust the chase and scene
speed within the range of 0.1 seconds to 10 minutes.
12. SOUND BUTTON - This button is used to activate sound active mode
to run a scene or chase.
13. FADE TIME FADER - This fader is used to adjust the scene or chase
fade time within the range of 0 seconds to 30 seconds. When set at 0
seconds the fade function is off.
14. BLACKOUT - The Blackout button has two functions. It can pause the
whole output of the contoller and it can reset all the channels to zero
and shut off all active scenes and chases, including relevant scene and
chase LED’s.
15. CHASE BUTTONS - These buttons are used for activating the chase
WiFly WLC16
Controls and Functions
sequence of programmed scenes.
16. RECORD BUTTON - This button activates program mode.
17. Bank UP & DOWN BUTTONS - Use these buttons to scroll through the
30 Banks.
18. LCD DISPLAY - This display shows the current activity or programming
state.
