ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 11
ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 10
Vortex 1200 System Menu
Dimmer Curve
- In this mode you can select the dimmer
curve.
1. Press the MENU button until “Dimmer Curve” is displayed,
press ENTER.
2. The current dimmer curve will setting will be displayed.
3. Press the UP or DOWN buttons to find your desired dimmer
curve and press ENTER to confirm. See the Dimmer Curve Chart
on page 31.
Slave Mode -
This will let you set the unit as a slave in
a master/slave configuration.
1. Press the MENU button until “Slave Mode” is displayed,
press ENTER. Either “Slave 1” or “Slave 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one fix-
ture the Master and then set the next fixture to “Slave 2”, the
fixtures will now have contrast movement to each other.
No DMX
-
This mode is used as a precaution mode. In
case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “No DMX” is displayed, press
ENTER.
2. Either “Hold”, “Blackout”, or “Show” will be displayed. Choose
an operating mode you would like the unit to start up in when
either power is applied or the DMX signal is lost.
• Blackout - If the DMX signal is lost or power is applied, the unit
Vortex 1200 System Menu
System Menu: When making adjustments press ENTER to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
DMX Address
-
Set the DMX Address -
1. Press the MENU button until “DMX Address” is displayed,
press ENTER.
2. “XXX” will now be displayed, “XXX” represents the displayed
address. Press the UP or DOWN buttons to find your desired
address.
3. Press ENTER to confirm, and then press and hold the MENU
button
for at least three seconds
to assign.
Channel Mode
- This will let you select your desired
DMX Channel mode.
1. Press the MENU button until “Channel Mode” is displayed,
press ENTER.
2. “XXChan” will now be displayed, “XX” represents the displayed
DMX channel mode. Press the UP or DOWN buttons to find your
desired Channel mode.
3. Press ENTER to confirm.
Show Mode
- Show modes 1 - 4 (Factory Shows).
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show X” will now be displayed, “X” representing a number
between 1-4. Press the UP or DOWN buttons to find your desired
show and press ENTER to confirm. After pressing ENTER, press
and hold the MENU button for at least 3 seconds to activate.
