ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 52
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 53
Vizi Roller Beam 2R
18 Channel DMX Mode
Channel Value
Function
14 SHUTTER & STROBE
128 - 159 PULSE EFFECT IN SEQUENCES
160 - 191 SHUTTER OPEN
192 - 223 RANDOM STROBE SLOW - FAST
224 - 255 SHUTTER OPEN
15 0 - 255 MASTER DIMMER 0% - 100%
16 0 - 255 FINE DIMMER INTENSITY
17 PAN/TILT MOVEMENT SPEED
0 - 225 MAX TO MIN. SPEED
226 - 235 BLACKOUT BY MOVEMENT
236 - 245 BLACKOUT BY WHEEL CHANGING
246 - 255 NO FUNCTION
18 LAMP ON/OFF, RESET & PROGRAMS
0 - 19 COLOR CHANGE NORMAL
20 - 29 COLOR CHANGE TO ANY POSITION
30 - 39 COLOR & GOBO CHANGE TO ANY
POSITION
40 - 59 LAMP ON
60 - 79 LAMP OFF
80 - 84 ALL MOTOR RESET
85 - 87 SCAN MOTOR RESET
88 - 90 COLOR MOTOR RESET
91 - 93 GOBO MOTOR RESET
94 - 96 SHUTTER/DIMMER MOTOR RESET
97 - 99 OTHER MOTOR RESET
100 - 119 INTERNAL PROGRAM 1
120 - 139 INTERNAL PROGRAM 2
140 - 159 INTERNAL PROGRAM 3
160 - 179 INTERNAL PROGRAM 4
180 - 199 INTERNAL PROGRAM 5
200 - 219 INTERNAL PROGRAM 6
220 - 239 INTERNAL PROGRAM 7
240 - 255 SOUND ACTIVE PROGRAM
Fuse Replacement: Locate and remove the unit’s power cord. Once
the cord has been removed located the fuse holder located inside the
power socket. Insert a flat-head screw driver into the power socket
and gently pry out the fuse holder. Remove the bad fuse and replace
with a new one. The fuse holder has a built-in socket for a spare fuse
be sure not to confuse the spare fuse with active fuse.
Vizi Roller Beam 2R
Lamp Replacement
Caution:
Always replace with the exact same type lamp and fuse, unless
otherwise specified by an authorized ADJ service technician. Replacing
with anything other than the specified part can damage your unit and will
void your manufactures warranty.
Warning:
If you continue to blow lamps or fuses, STOP using the unit.
Contact customer support for further instructions, you may have to return
the unit for servicing. Continuing to use the unit may cause serious damage.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace
the lamp. Please see page 7 for important information regarding the
discharge lamp. Do not handle the lamps with with bare hands!
1. Be sure to follow the proper handling procedures that deal with
discharge lamps.
2. Remove the three small screws (labeled A, B, & C) on the bottom
of the unit.
3. After removing the screws, gently remove the lamp access panel.
4. Carefully disconnect the two wires connected to the lamp (Pic A).
5. Next, located on the left side squeeze the lamp holding clips
togther and lift the holder (Pic B).
6. Replace the lamp with an exact match. Reassemble in reverse
order. Clear the lamp time after replacing the lamp.
Pic A
Pic B
