![background image](http://html1.mh-extra.com/html/american-dj/vizi-roller-beam-2r/vizi-roller-beam-2r_user-instructions_2923238019.webp)
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 36
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 37
Vizi Roller Beam 2R
System Menu
3. Use the UP or DOWN buttons to scroll through the 3 DMX Channel
Modes.
Standard Mode - This is 13 Channel Mode.
Basic Mode - This is 11 Channel Mode.
Extended Mode - This is 18 Channel Mode.
4. Press the MODE/ESC button once to return to the “User Mode
Set” menu. Use the UP or DOWN buttons to scroll through the Edit
modes. Press ENTER to select any of the Edit modes.
Edit User Mode – This function allows the user to make the actual
changes in the user defined modes that are created in the previous
function.
EDIT PROGRAM: - The fixture comes equipped with a built-in DMX
recorder that allows custom programs to be installed and recalled
directly from the fixture’s control board. Programs can be created and
stored using the fixture’s control board or by using an external DMX
controller.
Select Program – This function allows the user to select one of ten
of the user defined built-in programs. This program is then accessed
in “Function Mode” under “Program Run.”
Edit Program – This function allows the user to edit the internal built-
in programs.
Edit Scenes – This function allows the user to edit or define the
actual scenes that are stored in the user defined built-in programs
that are accessed in the previous step.
Rec Controller - The Vizi Roller Beam 2R features an integrated DMX
recorder. Preprogrammed scenes can be transmitted to the fixture via
any DMX compliant controller. This function allows those scenes to
be stored in to the fixture’s built-in memory and
then subsequently used to create the user-defined programs.
Vizi Roller Beam 2R
Error Codes
When power is applied, the unit will automatically enter a
“reset/test” mode. This mode brings all the internal motors to a
home position. If there is an internal problem with one or more
of the motors an error code will flash in the display in the form
of “XXer”, “XX” will represent a function number. For example,
when the display shows “03Er,” it means there is some type of
error with the channel 3 motor. If there are multiple errors during
the start-up process they will all flash in the display. For exam-
ple: if the fixtures has errors on channel 1 and channel 3 all at
the same time, you will see the error message flash “01Er”, and
“03Er repeated 5 times.
If an error does occur during the initial start-up procedure the
fixture will self-generate a second reset signal and try to realign
all the motors and correct the errors, if the errors persist after a
second attempt a third attempt will be made.
If after a third attempt all the errors have not been corrected the
fixture will make the following determinations:
1) 3 or more errors - The fixture cannot function properly with
three or more errors therefore the fixture will place itself in a
stand-by mode until subsequent repairs can be made.
2) Less than 3 errors - If the fixture has less than 3 errors, there-
fore most other functions will work properly. The fixture will
attempt to operate normally until the errors can be corrected by
a technician. The errors in question will remain flashing in the
display as a reminder of internal errors.
03Er – TILT movement error:
This message will appear after a fixture reset, if the tilt mag-
netic-indexing circuit malfunctions (sensor failed or magnet is
missing) or there is a stepper motor failure (defective motor or a
defective motor IC drive on the main PCB).
05Er – COLOR WHEEL error:
This message will appear after a fixture reset, if the head’s mag-
netic-indexing circuit malfunctions (sensor failed or magnet is