Fog Juice:
Before plugging your unit in be sure the fluid reservoir has been filled
with American DJ
®
brand fog juice. Not all fog juice is created equal,
using oil based fog liquid will void the manufactures warranty of your
fogger. You risk serious damage to your Shadow II™ and you may
SHADOW II
™
SET UP
NEVER POINT OR AIM THE SHADOW II™ TOWARDS PEOPLE
OR THEIR CLOTHING. THIS FOG MACHINE EMITS EXTREMELY
HOT VAPOR AND SHOULD BE USED WITH THE SAME CARE
THAT YOU WOULD OBSERVE WHEN USING AN ELECTRIC
KETTLE OR IRON.
SHADOW II
™
SAFETY WARNINGS
• Do not install this unit directly above people heads
•
Never point the output nozzle directly into peoples faces
•
Keep the fog machines output at least two (2) feet away from
people and surfaces.
•
Keep this unit in a well ventilated area.
•
Never attempt to service or repair this unit while plugged in to
power.
• Never touch the output nozzle while the unit is plugged in.
•
Observe the printed warning labels on the rear of the unit.
•
Do not use this unit if it becomes in disrepair.
•
Remember to only use Elation
®
brand fog liquid.
•
Never run the fogger dry of liquid. Always maintain an ample
supply of fog juice in the fluid reservoir.
•
Always replace the fuse with exact same type unless otherwise
specified to do so by an authorized Elation
®
service
technician.
•
Do not use oil based fog liquid!
void your manufactures warranty by not using American DJ
®
brand
fog juice. Running the fog machine dry will cause pump failure
and/or heater clogging. This is the largest cause of failure in fog
machines always maintain an ample supply of fog juice in your fog
machine.
Remote:
Plug your remote control into the female IEC connection on the rear
of the unit. Be sure that only the remote is plugged into this con-
nection, plugging in a power supply will damage the unit. Connect
the remote before plugging the unit in. The remote has a red LED
that will glow when the unit is plugged in. When the fogger has
warmed to its operating temperature the red LED will turn off indi-
cating that the unit is ready for operation. When the fogger has
dropped below operating temperature the red LED on the remote will
again glow indicating that the fogger’s heater is reheating to normal
operating temperature.
Power Supply:
The Shadow II™ is available in a 120v and 220v version. Because
line voltage may vary from venue to venue, you should be sure to
plug your power supply into a matching wall outlet before attempting
to operate you fogger. The Shadow II™ will draw up to 7A of power.
!IMPORTANT!
Be sure that the rated line voltage matches that of voltage
rating label on the fog machine.
Placement:
Place the fog machine on stable flat surface, do not tilt or stand the
unit on its’ side. You may hang the unit in flat position. When hang-
ing the unit be sure that it is not, mounted directly over people’s
heads.
SHADOW II
™
SET UP CONT.
SHADOW II
™
PACKING LIST
•
American DJ Shadow II™
•
10ft. Remote control
•
User manual
•
Warranty card
•
Hanging bracket and screws
SHADOW II
™
OPERATING INSTRUCTIONS
After connecting your units remote, connect your fogger’s power.
Once the machine has warmed up to temperature, the red L.E.D
light on the remote will go ‘OFF’. To emit fog, press the red button
©
American DJ Supply
®
www.americandj.com Shadow II Page 3
©
American DJ Supply
®
www.americandj.com Shadow II Page 4
