![background image](http://html1.mh-extra.com/html/american-dj/shadow-ii/shadow-ii_user-instructions_2922983003.webp)
The F-Timer/SH3 is a wired, timer remote
control that allows you three (3) different
operating modes.
• You may set your unit to fog at an
adjustable interval and an adjustable
blast duration.
• You may also set your unit to fog in
a continuous output pattern. Pressing
the continuous button on the remote will
blast the fog at its maximum level until
the heater must recycle. Then the fogger
will once again blast the fog output at its
maximum level. The remote will continue
this operating mode until the continuous function is turned off. While
in continuous blast mode be sure that you keep the fluid reservoir full
of fog juice.
• This remote also has a manual control function that allows you to
TO HELP PREVENT YOUR FOGGER FROM CLOGGING, WE
RECOMMEND USING AMERICAN DJ
®
CLEAN MACHINE™ LIQ-
UID. UNDER NORMAL USAGE USE CLEAN MACHINE AS NOR-
MAL MAINTENANCE ONCE A MONTH. CLEAN MACHINE IS
ALSO RECOMMENDED BEFORE STORING YOUR FOGGER
FOR MORE THAN ONE (1) WEEK. ITS LIKE A TUNE UP FOR
YOUR FOG MACHINE! CLEAN MACHINE REMOVES PARTICLE
BUILD UP IN THE HEATER AND PROLONGS THE LIFE OF THE
FOG MACHINE. CLEAN MACHINE IS AVAILABLE IN GALLON
OR QUART BOTTLES FROM YOUR LOCAL
AMERICAN DJ®
DEALER AND MAY BE USED IN ALL WATER BASED FOG
MACHINES.
SHADOW II
™
PREVENTATIVE MAINTENANCE
©
American DJ Supply
®
www.americandj.com Shadow II Page 5
SHADOW II
™
SERVICE & TROUBLE SHOOTING
If you experience low output, pump noise, or no output at all, dis-
connect the units main power immediately. Check the fluid level, the
external fuse, remote connection, and be sure the units plugged in
properly . If everything checks out and the unit still fails to operate
©
American DJ Supply
®
www.americandj.com Shadow II Page 6
SHADOW II
™
OPERATING INSTRUCTIONS CONT.
on the remote for desired length of time. The button is spring loaded,
so fog will only emit for as long as you are depressing the output but-
ton. It may take up to 30 seconds for fog output during initial start-
up. If fog does not come out, after holding the button down the red
button for 30 seconds, check the fluid tank and hose to make sure
there is fluid going through the hose. If fluid is not traveling through
the system try one more 30 second burst. Do not continue to push
the remote output button as this may severely damage your
unit. If fluid still seems not to be traveling through the system unplug
your unit and return it to your dealer for inspection.
The unit must maintain a specific operating temperature to emit fog,
when it drops below this temperature it must reheat. When the
Shadow II™ reheats to its proper operating temperature, the red
L.E.D. on the remote will glow. You will not be able to emit fog when
the unit is reheating. The reheat process usually takes about a
minute, when the red L.E.D on the remote turn off you will be able
to emit fog.
SHADOW II
™
OPTIONS
F-Timer/SH3: Wired timer remote control
SHADOW II
™
SERVICE & TROUBLE SHOOTING
correctly, the unit may require service. Do not continue to push
the remote output button as this may severely damage your
unit. Return the machine to your authorized American DJ
®
dealer.
If you are unable to return your unit to an authorized dealer you
may return your unit directly to American DJ
®
. All returned service
items whether under warranty or not, must be freight pre-paid and
accompany an Return Authorization (R.A.) number. If the unit is
being returned for a warranty repair you must provide a proof of
purchase invoice.
Occasionally the fogger will spurt output from it’s nozzle, this is
normal. This is caused by excess fluid building up in the heater
exchange until it has to be released. The fogger will usually spurt
fluid after large blast, but may spurt at any time. A fogger may even
spurt out fog for a few minutes after it has been powered down.