American DJ OCTO BEAM RGBW, User Instructions

Page: 5 / 10

ADJ Products, LLC - www.adj.com - Octo Beam RGBW Instruction Manual Page 9 ADJ Products, LLC - www.adj.com - Octo Beam RGBW Instruction Manual Page 8
Octo Beam RGBW System Menu
ADDR
- DMX Address Setting via control board -
1. Press the MENU button until “ ADDR ” is displayed, press
ENTER.
2. “XXX” will now be displayed, “XXX” represents the displayed
address. Press the UP or DOWN buttons to find your desired
address.
3. Press ENTER to confirm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not
fall into DMX mode, press and hold the MENU button for at least
3 seconds.
CHND
- This will let select your desired DMX channel
mode.
1. Press the either the MENU button until “ CHND ” is displayed,
press ENTER. Either “ 1CH ”, “ 8CH ” or “ 10CH ” will be displayed
2. Press the UP or DOWN buttons to find your desired DMX
channel mode and press ENTER to confim and exit.
SLND
- This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until “ SLND ” is displayed, press
ENTER. Either “ MAST ”, “ SL 1 ” or “ SL 2 ” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Slave 1 (SL 1) and then set the next fixture to Slave 2 (SL 2),
in doing this the fixtures will now have contrast movement to
each other.
SHND: SH 0 - SH 12
- Show modes 0 - 12. Show
mode can run with or without sound active mode on.
Octo Beam RGBW System Menu
1. Press the MENU button until “ SHND ” is displayed, press
ENTER.
2. “
SH X ” will now be displayed, “X” representing a number
between 0-12 will be displayed. Shows 1-12 are preset shows,
while “ SH 0 ” is random show. Press the UP or DOWN buttons to
find your desired show.
3. Once you have found your desired show press ENTER, and
then press and hold the MENU button for at least 3 seconds to
confirm.
DIND
- Dimmer mode. Control the output intensity of each
light.
1. Press the MENU button until “ DIND ” is displayed, press
ENTER.
2. Either “
FULL ” or “LED X” will now be displayed, “X” repre-
senting a number between 1-8. If you select “FULL” all 8 LEDs
will be full on.
3. You can select 1-8 LEDs and adjust the output intensity to your
liking. Press ENTER to select your desired LED and use the UP
and DOWN buttons to adjust the intensity.
SOUN
- In this submenu you can activate sound active
mode.
1. Press the MENU button until “ SOUN ” is displayed, press
ENTER.
2. Either “
ON ” or “ OFF ” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. When you have made your selection, press the ENTER, and
then press and hold the MENU button for at least 3 seconds to
confirm.
SENS
- Sound sensitivity control.