American DJ Inno Color Beam 12, User Instructions

Page: 5 / 10

Inno Color Beam 12 System Menu Inno Color Beam 12 System Menu
2. “ SH X ” will now be displayed, “X” representing a number
between 0-4. Shows 1-4 are preset shows, while “ SH 0 ” is random
show. Press the UP or DOWN buttons to find your desired show.
3. Once you have found your desired show press ENTER, and
then press and hold the MENU button for at least 3 seconds to
confirm.
SOUN
- In this submenu you can activate sound active mode.
1. Press the MENU button until “ SOUN ” is displayed, press ENTER.
2. Either “ ON ” or “ OFF ” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. When you have made your selection, press the ENTER, and
then press and hold the MENU button for at least 3 seconds to
confirm.
DNST
- This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “ DNST ” is displayed, press ENTER.
2. Either “ MASL ”, “ BLND ”, or “ LAST ” will be displayed. Choose an
operating mode you would like the unit to start up in when power
is applied or the DMX signal is lost.
•
MASL (Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
•
BLND (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
•
LAST (Last State) - If the DMX signal is lost the fixture will stay in
the last DMX set up. If power is applied and this mode is set, the
unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
LED
- With this function the LED display will turn off after 2
minutes.
1. Press the MENU button until “ LED ” is displayed, press ENTER.
2. Either “ ON ” or “ OFF ” will now be displayed. Press the UP or
DOWN buttons to select “ ON ” to keep the LED display on at all
times, or “ OFF ” to allow the LED display to turn off after 2 min-
utes. Press any button to turn the LED display on again.
3. Press ENTER to confirm your selection.
PAN
- Pan Inversion
1. Press the MENU button until “ PAN ” is displayed, press
ENTER. Either “ YES ” or “ NO ” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until “ YES ” is displayed, press ENTER to confim. To deactivate
Pan inversion, select “ NO ” and press Enter.
TILT
- Tilt Inversion
1. Press the MENU button until “ TILT ” is displayed, press ENTER.
Either “ YES ” or “ NO ” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until “ YES ” is displayed, press ENTER to confim. To deactivate
Tilt inversion, select “ NO ” and press Enter.
DISP
- This will “flip” the LED display
1. Press the MENU button until “ DISP ” is displayed, press
ENTER.
©
American DJ Supply
®
- www.americandj.com - Inno Color Beam 12 User Manual Page 9
©
American DJ Supply
®
- www.americandj.com - Inno Color Beam 12 User Manual Page 10