Energy DMX™ Lamp Replacement
Energy DMX™ Lamp Replacement
Unscrew the six phillips screws that
run along the bottom sides of the
unit (three on each side).
Seperate the base and the cover.
Unscrew and disconnect the three
wires from the PCB.
Push the lamp holders out to remove
the lamp.
Remove and replace the lamp with
an exact match. Remove the silicon
wire sheath from the old lamp, and
slide it over the new lamps exposed
wires.
Connect the three wires to the cor-
rect points on the PCB.
Reassemble in reverse order.
Never move the fixture until the lamps have had ample time to
cool. Remember, lamps are not covered under warranty conditions.
Caution! Never open the unit when in use. Always disconnect the
main power and allow the fixture ample time to cool before attempt-
ing to replace the lamp. Again, please remember to always replace
with the exact same type lamp.
©
American DJ
® -
www.americandj.com - Energy DMX™ Instruction Manual Page 13
©
American DJ
® -
www.americandj.com - Energy DMX™ Instruction Manual Page 14
