Energy DMX™ Lamp Replacement
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
techni-
cian. Replace with anything other than the specified part can damage
your unit and will void your manufactures warranty.
Warning:
If after you have replaced the lamp or fuse and you con-
tinue to blow either one, STOP using the unit. Contact customer sup-
port for further instructions, you may have to return the unit for ser-
vicing. Continuing to use the unit may cause serious damage.
Lamp Replacement:
Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Again, please remem-
ber to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling strobe
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the six phillips screws that run along the bottom sides of
of the unit (three on each side).
3. Seperate the base and the cover.
4. Unscrew and disconnect the three wires from the PCB.
Remember which wire went where.
5. Push the lamp holders out to remove the lamp.
6. Remove and replace the lamp with an exact match. Remove the
silicon wire covers from the old lamp, and use them to cover the
new lamp wires’.
7. Connect the three wires to the correct points on the PCB.
8. Reassemble in reverse order.
For illustrated instructions on how to replace the lamp, see the
next page.
Strobe Lamp Warning!
This fixture is fitted with a
strobe lamp which are highly susceptible to dam-
age if improperly handled. Never touch the lamps
with your bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture until
the lamps have had ample time to cool. Remember,
lamps are not covered under warranty conditions.
Locate and remove the unit’s power cord. Once the cord has been
removed locate the fuse holder inside the power socket. Insert a flat-
head screwdriver into the power socket and gently pry out the fuse
holder. Remove the bad fuse and replace with a new one. The fuse
holder has a built-in socket for a spare fuse be sure not to confuse the
spare fuse with active fuse.
Energy DMX™ Fuse Replacement
©
American DJ
® -
www.americandj.com - Energy DMX™ Instruction Manual Page 12
©
American DJ
® -
www.americandj.com - Energy DMX™ Instruction Manual Page 11
Energy DMX™ DMX Traits
DMX512 configuration
Channel 1
Channel 2
DMX512
Level range
0~255
Strobe
Speed
Dimmer
240~255
Speed 15
Dimmer 15
224~239
Speed 14
Dimmer 14
208~223
Speed 13
Dimmer 13
192~207
Speed 12
Dimmer 12
176~191
Speed 11
Dimmer 11
160~175
Speed 10
Dimmer 10
1444~159
Speed 9
Dimmer 9
128~143
Speed 8
Dimmer 8
112~127
Speed 7
Dimmer 7
96~111
Speed 6
Dimmer 6
80~95
Speed 5
Dimmer 5
64~79
Speed 4
Dimmer 4
48~63
Speed 3
Dimmer 3
32~47
Speed 2
Dimmer 2
16~31
Speed 1
Dimmer 1
0~15
Stopped
Blackout
