54
Below is a description of the features in this menu:
Preset:
Use this dropdown menu to select a preset. Please note the preset and smart plan must be enabled to add
an IVS rule type.
No.:
Provides the order in which the IVS rules will be displayed in the menu.
Name:
Allows the user to customize a name for their rule. Double click the name in the Name column to modify.
Rule Type:
This dropdown menu allows the user to select an IVS rule type (Tripwire or Intrusion).
Schedule:
Allows the user to set a schedule in which the IVS rule will be triggered.
Direction:
This dropdown menu allows the user to set which direction the object will be going for the tripwire to
be triggered. It can be set left, right, or in both directions (A<->B).
Object filter
: The object filter checkboxes allow the camera to be triggered only when a specific object, such as a
human or car, is detected by the camera. Both effective object checkboxes can be activated at the same time.
Human:
This checkbox allows the camera to be triggered only when a human figure is detected.
Motor Vehicle:
This checkbox allows the camera to be triggered only when a vehicle has been
detected.
Record:
This checkbox allows the user to enable the camera to record video when an IVS event is triggered.
Record Delay
: This field specifies, in seconds, how long the delay between IVS events should be. The default is 10
seconds however this can be modified between 10~300 seconds.
Relay Out
: This checkbox allows the user to enable the camera to trigger a connected alarm (connected to the
alarm port on the back of the camera) when a motion detection alarm is triggered.
Alarm Delay
: This field specifies in seconds how long the delay between alarm activation and Relay alarm
activation should be.
Send Email:
This checkbox allows the user to enable the camera to send an email when an IVS event is triggered.
PTZ:
This checkbox allows the user to enable PTZ events to be sent from the camera. This event can be sent via
email alerts or via the web interface directly.
Snapshot
: This checkbox allows a snapshot of the IVS event to be sent via Email when triggered.
Draw Rule
: This option allows the user to use their mouse to customize (draw) a rule/area on the screen. This will
be the area or line in which an IVS rule will be triggered.
Clear:
This option is used to clear the drawn rule set on the live monitor screen.
Target filter:
Sets a maximum and minimum size in which an event will be triggered.
Clear:
Clears the modified target area to draw the target area on the live monitoring screen.
Draw Target:
Allows the user to set a target area on the live monitor screen.
An IVS event will not occur outside
the target box.
Pixel Counter
: Used to measure and set the number of pixels in the target area on the live monitoring screen.
To reset to default settings, click the
Reset Defaults
button. To refresh the page, click the
Refresh
button. To save
the settings, click the
Save
button.
Setting a Tripwire
1.
Select Tripwire from the
Rule Type
drop down menu. Set a name for the rule by double clicking the mouse over
the Name of the rule.
2.
Click on
Setup
to set a schedule, set your periods (if any) and click
Save
to continue.
3.
In the
Direction
menu, choose which direction the object will be going for the tripwire to be triggered.
4.
Enable the Record checkbox to record the event.
5.
Check the
Send Email
and
Snapshot
checkboxes if you would like a snapshot of the event emailed to you. A valid
Email address must be established in the camera prior to enabling this setting.
6.
Click the
Draw Rule
option and use your mouse to draw the rule on the live monitoring screen. Once the rule
has been drawn click the monitoring screen to finish setting the rule. The drawn line will turn blue/green when
set depending on the browser you are using.