AMCI SD4840EK, User Manual

Page: 83 / 104

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
83
TASK 2
I
NSTALLING THE
SD4840EK
2.1 Safe Handling Guidelines
2.1.1 Prevent Electrostatic Damage
Electrostatic discharge can damage the SD4840EK. Follow these guidelines when han-
dling the module.
1) Touch a grounded object to discharge static potential before handling the module.
2) Work in a static-safe environment whenever possible.
3) Wear an approved wrist-strap grounding device.
4) Do not touch the pins of the I/O connector.
5) Do not disassemble the module
6) Store the module in its anti-static bag and shipping box when it is not in use.
2.1.2 Prevent Debris From Entering the Module
During DIN rail mounting of all devices, be sure that all debris (metal chips, wire
strands, tapping liquids, etc.) is prevented from falling into the module. Debris may
cause damage to the module or unintended machine operation with possible personal
injury. The DIN rail for the modules should be securely installed and grounded before
the modules are mounted on it.
2.1.3 Remove Power Before Servicing
Remove power before removing or installing any modules.
-+
2.2 Mounting
2.2.1 Dimensions
Figure T2.1 shows the dimensions of
an SD4840EK.
This chapter gives detailed information on installing the SD4840EK. The SD4840EK
is designed to be DIN rail mounted. The EtherCAT connection allows the drive to
be mounted near the motor, which minimized power loss in the motor cable.
Figure T2.1 SD4840EK Outline
4.47"
(113.5)
3.
90
"
(99.
1)
4.
55
"
(1
15.
6)
0.89"
(22.6)
I/O Mating Connector
Network Connector Location
Motor Connector Location
0.26"
(6.6)
STATUS
RUN ERR