S
ET
THE
IP A
DDRESS
AND
P
ROTOCOL
NXEE2 User Manual
ADVANCED MICRO CONTROLS INC.
38
2.2c Use the AMCI Net Configurator Utility (continued)
2.2c.6 Press the [SCAN] button and Connect to the NXEE2
Pressing the [Scan] button will open the window shown in figure T2.5. The NXEE2 will appear in the scan
list only if the unit and your network interface are on the same subnet. Optionally, you can press the [Manual
Connect] button and enter the IP address of the NXEE2.
Figure T2.5 Scan for NXEE2
If scanning for the NXEE2, click on the IP Address of the module and click on the [Connect] button. The Net
Configurator utility will connect to the unit.
2.2c.7 Click on the "Allow IP..." Checkbox to Access the IP Settings
Figure T2.6 below shows the screen that results when you are connected to the NXEE2. In order to change
the IP Address of the unit, you must first click on the checkbox next to the text “Allow IP configuration
changes. You will need to restart the device.” Once the checkbox is selected, the [Set IP Address] button will
be enabled.
Figure T2.6 Enable IP Address Changes
Summary of Contents for NXEE2
