50D0092 Rev 4 Feb 2005
Page 4 of 9
Ambient Technologies
A Division Of
Installing Batteries:
The Touch Light transmitter uses two (2) “AA”- size batteries. To install
batteries,
1.
Press down the battery door tab and lift up and remove the
battery door.
2.
Install the battery.
3.
Close the battery door by snapping in place
4.
Repeat the above step for the other battery.
5.
When both batteries are installed, the transmitter will
initialize for 10 seconds and then is ready for use.
6.
The batteries should be replaced at least once every 6
months or when the battery icon indicator flashes.
Setting Privacy (DIP) Switch on Receiver and Transmitter:
The remote receiver and transmitter privacy (DIP) switches are preset at the factory. In the event of activation or
interference from other nearby transmissions, reset the code using the following procedure:
1.
Slide the code switches on the transmitter or receiver to your choice of ON or OFF position. Switches #1
to #4 are preset to “ON” for both the transmitter and receiver.
2.
The switches on the transmitter and receiver must match in order for the system to work.
3.
To check, touch the transmitter groove surfaces for at least 1 second and , the transmitter will emit a beep,
and the receiver indicator light will blink. If not repeat step 2.
4.
The system is now ready to operate.
WARNING
Do not use two (2) or more remote control systems in the same area with the same dip switch
settings, as they will communicate with each other. This may cause the appliances to
malfunction.
Optional Auto Shutdown:
