Amazone Pantera 4504, Operating Manual

Page: 236 / 286

Cleaning, maintenance and repair
236 Pantera 4504 CP plus BAG0230.2 07.21
15.7.10
228B
Hydraulic oil
Correct oil level at oil temperature

60° Celsius – Centre inspection glass

20° Celsius – lower third of inspection glass
The oil quantity is correct when the oil level is
located

at the lower third (cold oil),

up to the middle
of the inspection glass.
Where required, oil can be refilled through a
filling opening on the top side of the tank.
If the oil level falls below the minimum measure-
ment or the oil temperature increases too high, a
warning signal is output in the cabin.
Oil change:
1. Stop the engine, allow the hydraulic oil to
cool sufficiently so that there is no risk of
burns.
2. Place an oil drip pan under the hydraulic
tank.
3. Unscrew the oil drain screw on the bottom
side of the tank.
4. Drain the oil.
5. Screw in the oil drain plug with a new seal
and tighten.
6. Fill up the hydraulic fluid.

Details for quality / viscosity, see Seite
224.

Filling quantity 120 litres.

The inspection glass is decisive for the
filling quantity.
7. Check the oil level.
Fig. 4
CAUTION
Risk of scalding when draining due to hot oil!
Hydraulic oil filter

Changing the hydraulic oil filter can be carried out when the
hydraulic oil tank is filled.

Collect any possible escaping oil.

Risk of scalding when draining due to hot oil!