NITID N26_N36_N46
Oct 2017
18
Amate Audio
EQ
EQ Low
-2.50dB
Limiter
THRESH.
0.0 dB
Limiter
THRESH.
-12.0dB
The gains can be adjusted between +3dB and -6dB. The current values are
displayed on the right side of the display (in dB).
When changing the Main Gain settings, the actual sensitivity of the system
is being changed too. When setting the value to +3dB, the input sensitivity
will be reduced by 3dB (from n8dBu to +5dBu).
4.4.2. 5-band EQ Menu
Inside the EQ menu, five parametric equalizers with fixed Q (Q=1) are available: Low
(L), Low-Mid (LM), Mid (M), Mid-High (MH) and High (H). The central frequency for
each band is: 100Hz, 250Hz, 1kHz, 2.5kHz and 10kHz, respectively.
It is possible to modify the gain of each band b3dB and -6dB. The current
edited value is displayed in the top right side of the display.
Press OK to start editing the EQ Low (left bar). The cursor will blink to show that the
value is being edited. Use the Circular key to modify the value.
At this point use the MENU key to change between the available EQ. Press OK to
finish editing.
4.4.3. Limiter Menu
In the Limiter Menu, it is possible to modify the Threshold setting of the internal DSP
peak limiter. Press OK to start editing the THRESH value (left bar). The cursor will
blink to show that the value is being edited. Use the Circular key to modify the value,
and press OK to finish editing.
The
level bars TH, GR and OUT provide additional information when an input signal is
connected to the device.
TH (Threshold): Shows the actual value of the limiter threshold (cursor).
Additionally, the bar will display the input level. The level of the threshold in
dB is also displayed next to the bar in figures.
Fig. 19.
EQ display (left) and EQ Low while editing (right)
Fig. 20.
Limiter display (left) and Limiter Threshold while editing (right)
