![background image](http://html1.mh-extra.com/html/amano/pe310as/pe310as_operators-manual_2918224009.webp)
Unpacking the Machine
Unpack the machine with caution. The machine is
shipped boxed on a wooden pallet. To unpack machine:
1. Cut and remove bands holding the box to the pallet.
2. Remove staples attaching the box to the platform at
the bottom edge of the box.
3. With two people, one at either end of the box, lift box
straight up and off machine.
4. Remove any loose or miscellaneous items that are
not strapped to the pallet.
5. Cut and remove bands securing the machine to the
pallet.
6. Carefully take the machine off of the pallet by means
of a wooden or metallic ramp.
7. Cut and remove bands securing the batteries (if
applicable) from the pallet.
8. Open the battery cover and remove any components
that may be inside the battery compartment.
9. Check machine for any damage that may have
occurred during transport.
10. Read carefully the contents of this operators manual.
11. Install the batteries (See the “Installing Batteries”
section).
Transporting the Machine
When shipping the machine, make sure the batteries are
disconnected. It is recommended that the batteries be
removed from the machine during transport. Remove
the splash skirt, pad/brush, and squeegee before
loading to prevent damage to these components. Secure
the machine to the transporting vehicle so that it does
not move during transport. Always engage the parking
brake while the machine is being transported. For a
longer transport, it is recommended to pack the machine
in its original box, with the batteries removed.
To repack the machine, refer to the “Unpacking the
Machine” section, using the original packing materials
and container.
Installing Batteries
Check the batteries for any damage prior to installation.
Make sure there are no cracks or other external
damage.
1. Disconnect the battery plug from the back of the
machine.
2. Lift up the battery cover to access the battery
compartment.
3. Place the batteries in the battery compartment as
shown.
4. Clean the battery terminals and battery cables. Apply
a film of dielectric grease to terminals.
DANGER! Incorrect connection of batteries can
cause an explosion and/or serious injury.
5. Connect the batteries as shown in the battery
connection diagram.
Note: Red Cables are (
+
) Positive & Black Cables
are (
-
) Negative.
6. Double check the battery connections.
7. Connect the battery plug at the back of the machine
to the machine.
9
PROPOSITION 65 WARNING
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
Machine Preparation
Summary of Contents for PE310AS
