Amano PE310AS, Operator'S Manual

Page: 11 / 32

11
Main Key Switch
Turns the machine on and off.
Vacuum Switch
Turns on the vacuum motor on and off.
Traction Breaker
Over current protection for the traction motor. This is a
7A breaker. If the traction forward lever is pressed and
the machine does not traverse, turn the machine off and
press the breaker to reset.
Pad Motor Switch
Turns the pad drive motor on and off. This switch also
opens the solenoid valve to allow solution to flow to the
pad. The solenoid valve will close when the switch is
turned off.
Battery Level Indicator
Displays the charge level of the battery. There are three
lights and the top green light indicates the battery is fully
charged. The bottom red light indicates the battery pack
needs to be recharged. Stop using the machine when
the red light is illuminated to prevent damage to the
machine.
Traction Forward Lever
Pulling back on the traction forward lever will make the
machine move forward. The further you pull back the
faster the machine will traverse. This machine does
not have reverse. If you need the machine to back-up,
release the traction forward lever and pull the machine
backwards. If the squeegee is in the lowered position,
you will need to raise the squeegee before pulling the
machine backwards.
Parking Brake
The parking brake will prevent the machine from moving
while not in use or being transported. The parking brake
should be engaged when the machine is not in use or
left unattended. Always disengage the parking brake
while in use to prevent damage to the drive components.
Engage the parking brake by pulling back on the brake
lever and push the red latch into one of the notches. To
release the parking brake, pull on the brake lever and
the red latch will automatically release.
Squeegee Lift Lever
This lever will manually lift and lower the squeegee
assembly. To lower the squeegee, pick up on the lever
and rotate it towards the right side of the machine.
Allow the lever to fall and the squeegee will rest on the
floor. When you need to lift the squeegee, pick up on
the lever and rotate towards the center of the machine.
Place the lift lever in the notch of the lever catch plate
and allow it to rest in place.
Recovery Tank Clean Out
When the recovery tank needs to be thoroughly cleaned
or there is an obstruction at the drain hose, removing
the recovery tank clean out cap will provide access
to the inside of the recovery tank. Always be sure to
reinstall and tighten the clean out cap before using the
machine.
Recovery Tank Drain Hose
This drain hose will allow you to drain the dirty water
out of the recovery tank. Always be sure to reinstall the
drain plug in the end of the hose after draining.
Pad / Brush Pedal
The foot pedal will raise and lower the pad drive
assembly. To lower the pad drive assembly, using
your foot, press down on the pedal and slightly rotate
toward the center of the machine. Once the pedal is in
the channel, slowly lower the pad drive assembly until
it rests on the floor. To raise the pad drive assembly,
using your foot, press down on the pedal and rotate the
pedal outward until it is captured in the lift guide bracket.
Solution Adjustment Lever
This lever adjusts the amount of solution being put on
the floor while the pad is turning. Raising the lever all
the way up is the maximum amount of solution flow.
Pushing the lever all the way down will shut off flow of
solution.
Solution Tank Drain Hose
Unthread the cap on the end of the hose and drain any
remaining solution in the solution tank. The clear hose
also serves as an liquid level gauge to determine how
much solution is left in the solution tank.
Solution Tank Fill
Remove the fill cap and add solution and cleaner to the
solution tank.
Recovery Tank Access
Remove the cap to gain access to the inside of the
recovery tank. Use this access to rinse the recovery tank
after it has been drained.