December 1997
87
RS1300003 Rev. 0
Kit Instructions
1/16 inch (2 millimeter) Panels
Caution
To prevent property damage, place masking tape on
back of panel at each corner. Tape prevents panel
from damaging doors.
1. Cover outside edges of panels with masking tape.
Place several evenly spaced strips of masking tape
on rear of panels.
2. Slide decorator door panels into place until panels
are secure under handle trim and inserts.
3. Install side door trim by peeling off 1 1/2 inches
(38 millimeters) of backing. Place trim against top
corner of refrigerator cabinet over edge of top trim.
After checking placement, peel off backing and
press into place. Place side door trim over edge of
bottom trim.
1/4 inch (6 millimeter) Panels
Important
Confirm front surface of decorator door panels and trim
are facing forward when installing trim.
1.
DS19E, DS19S and DS21S Kits
Install 1/4 inch (6 millimeter) refrigerator door top
retainer (Item #9) by placing trim at an angle on
top edge of panel. Align straight end of trim flush
with panel corner. Press trim onto panel. Install
refrigerator door side retainer (Items #16 or #17),
refrigerator door bottom retainer (Item #9) then
refrigerator door side retainer (Items #16 or #17)
on panel. Notched end of trim must overlap
straight end of previously installed trim. Confirm
trim is secure.
DS20E and DS20S Kits
Install 1/4 inch (6 millimeter) refrigerator door top
retainer (Item #10) by placing trim at an angle on
top edge of panel. Align straight end of trim flush
with panel corner. Press trim onto panel. Install
refrigerator door side retainer (Item #18) on right
side of panel then refrigerator door bottom retainer
(Item #11) on panel. Notched end of trim must
overlap straight end of previously installed trim.
Confirm trim is secure.
2.
DS19E and DS19S Kits
Install 1/4 inch (6 millimeter) upper and lower
freezer door top retainers (Item #6) by placing trim
at an angle on top edge of panel. Align straight end
of trim flush with panel corner. Press trim onto
panel. Install upper and lower freezer door right
side retainers (Items #12 or #14, respectively),
upper and lower freezer door bottom retainers
(Item #6) then upper and lower freezer door left
side retainers (Items #12 or #14, respectively) on
panel. Notched end of trim must overlap straight
end of previously installed trim. Confirm trim is
secure.
DS20E and DS20S Kits
Install 1/4 inch (6 millimeter) upper and lower
freezer door top retainers (Item #7) by placing trim
at an angle on top edge of panel. Align straight end
of trim flush with panel corner. Press trim onto
panel. Install upper and lower freezer door left
side retainers (Items #13 or #15, respectively),
upper and lower freezer door bottom retainers
(Item #8) on panels. Notched end of trim must
overlap straight end of previously installed trim.
Confirm trim is secure.
