Troubleshooting–T2 and VP Models
RS5320010 Rev. 1
22
Cook Condition
Display starts counting down.
Yes
b
READY
Place cup of water in
oven and close oven door.
Open oven door, water is properly heated?
Beep not programmed into oven.
Pad not programmed.
Inoperative touch panel.
1.
2.
3.
NO
NO
Yes
Push pad number 1.
Pad beeps when pushed?
Broken or improper wire connections.
4.
POWER
COOK
LEVEL
:10
Heats very slowly.
NOTE: Verify by performing power test.
One inoperative diode.
One inoperative capacitor.
One inoperative magnetron.
Inoperative or misadjusted interlock switch assembly.
Broken or improper wire connection.
1.
2.
3.
4.
5.
No heat.
Inoperative triac.
Inoperative diodes.
Inoperative capacitors.
Inoperative control board.
Inoperative or misadjusted interlock switch assembly.
1.
2.
3.
5.
6.
Inoperative high voltage transformer.
4.
Oven is operating properly.
NOTE:
Shut down after cook cycle - door closed - 25 seconds.
Shut down, door open - approximately 5 minutes.
After shut down, display goes blank.
Display
Display
Broken or improper wire connections.
7.
