5.40
Remote input (digital inputs) 1 pull up/down operation
Section:
d.in
Display:
d.in.1 P.UP
Range:
OPEn
,
High
,
Lo
Default Value:
High
Default Access Level
4
Function number
4A50
This function sets the voltage level present on the digital input terminal. If set to
High
a 5VDC voltage will be
placed on the input terminal via a pull up resistor and a short circuit to ground or voltage below 2V will be required
to activate the remote input. If set to
Lo
then the input terminal will be connected to ground via a pull down resistor
and a voltage between 5 and 24VDC will be required at the input to activate the remote input. If set to
OPEn
then
both the pull up and pull down resistors will be taken out of circuit and the terminal voltage will be “floating”, this
choice can be used when input devices are used which may supply their own voltage to the digital input terminal,
maximum acceptable voltage is 24VDC.
5.41
Remote input (digital inputs) 1 input level
Section:
d.in
Display:
d.in.1 LuI
Range:
High
,
Lo
Default Value:
Lo
Default Access Level
4
Function number
4A58
This function sets the input level required to activate the remote input. A setting of
Lo
means that a low voltage
usually 0V or a short circuit to ground will activate the remote input. A setting of
High
means that a voltage of 5
to 24V is required to activate the remote input.
5.42
Remote input (digital inputs) 2 pull up/down operation
Section:
d.in
Display:
d.in.2 P.UP
Range:
OPEn
,
High
,
Lo
Default Value:
High
Default Access Level
4
Function number
4A51
This function sets the voltage level present on the digital input terminal. If set to
High
a 5VDC voltage will be
placed on the input terminal via a pull up resistor and a short circuit to ground or voltage below 2V will be required
to activate the remote input. If set to
Lo
then the input terminal will be connected to ground via a pull down resistor
and a voltage between 5 and 24VDC will be required at the input to activate the remote input. If set to
OPEn
then
both the pull up and pull down resistors will be taken out of circuit and the terminal voltage will be “floating”, this
choice can be used when input devices are used which may supply their own voltage to the digital input terminal,
maximum acceptable voltage is 24VDC.
LD5TMRMAN-1.1-0
45 of