Timekeeper™
Users Manual
01/11/20
Configuration and Setup.
The setup procedure is normally performed at the factory when you order the product. Occasionally, you may need to
make changes to the setup parameters. The setup parameters are summarized below.
•
The
Timer Mode
determines whether the display shows Days, Hours, Minutes, Seconds or 100ths of a
second.
•
The
Mode Setup
affects the function of the remote inputs and other system functions.
•
The
Beep
parameter affects the beep duration and beep mode.
•
The
Unit Address
is used when receiving communications from other devices. Range 0-31.
•
The
Extended unit address
has a range of 000 to FFF and is used with the serial communications port.
•
The
SERCMD
determines the number of digits transmitted on the serial communications port to a remote
display.
•
Time of day clock and remote control
functions.
•
Baud rate
of the serial communications port. 1,200 to 115,200.
•
Button Delay
for the remote inputs IN1, IN2, IN3 and IN4.
Beeper Modes
The Timekeeper™ has several beeper modes: Single beep; Beep at each of the warning times; Pulsing beep until reset;
steady beep until reset, and beeper disabled. Press and hold the
Mode
button until the display changes. Turn the
Knob
to select the desired beeper mode.
The following table describes the various options. Multiple options can be selected by adding the respective numbers
together.
Value
Description
bb00
Mode 0: Beeper off.
bb01
Mode 1: A single beep when the timer reaches zero.
bb02
Mode 2: Continuous pulsing beep when the timer reaches zero. Pressing the
Reset
button stops the
beep.
bb03
Mode 3: Continuous steady beep when the timer reaches zero. Pressing the
Reset
button stops the
beep.
bb04
Mode 4: Beep when the timer is started.
bb05
Mode 5: Beep when the timer is started and a single beep when the timer reaches zero.
bb06
Mode 6: Beep when the timer is started and continuous pulsing beep when the timer reaches zero.
bb07
Mode 7: Beep when the timer is started and continuous steady beep when the timer reaches zero.
bb08
Mode 8: Beep at the warning times. You can add 8 to any of the other modes. Ie: Mode 9 is beep at
the warning times and at zero.
Note: See
Beeper and relay setup
options for additional beep options. (Revision 36)
Select the special timer mode
VERSION=5C
Page 15 of 33
