alza Tools AT-CCS20V, User Manual

Page: 15 / 80

15 ENGLISH
BASIC USE
LASER FOCUS
Warning: Laser radiation. Do not look into the beam. Class 2 laser.
Laser aiming is started with the button 9 and the laser illuminates until the button is pressed again.
• Mark the cutting plane on the material.
• Set the depth and, if necessary, the cutting angle as required.
• Turn on the laser with button
9 and adjust the saw so that the laser trace lies on the marked cutting
plane on the material.
• Start the engine and make a cut at full saw speed (after approximately 2 seconds).
• Switch off the laser when the cut is complete.
CUTTING
ATTENTION:
When cutting, always move forward in a straight line without pushing the saw to the
sides. Pressing or turning the saw overloads the motor, which results in a faster discharge of the bat-
tery and overheating of the machine. In the worst-case scenario, the saw can recoil and cause injury.
• Always hold the saw firmly by both handles.
• Place the saw base plate on the material without touching the blade teeth.
• Switch on the machine, wait for the engine to spin completely and make a smooth cut to the end;
keep the saw straight. For best results, move at the same speed.
• After releasing the switch, wait for the blade to stop before putting the saw down.