alza Tools AT-CCS20V, User Manual, Page: 13 / 80

13 ENGLISH
TIPS FOR EFFICIENT BATTERY USE
• Charge the batteries before they are completely discharged.
• If the performance of the machine decreases, stop using it and replace or charge the battery. Using
the machine with the last remaining battery power may damage the battery.
• Do not charge the batteries at high temperatures. The batteries are hot immediately after use.
When such a battery is charged, the chemical structure of the cells degrades, and the battery life is
shortened. Therefore, allow the batteries to cool before charging.
• The batteries can only be charged and used in the temperature range of 5 ° C to 30 °C. There is
a risk of damage to the cells. Always allow the batteries to reach normal temperature.
Note:
Failure to follow these instructions can damage the batteries and charger or cause an injury.
Warning! Do not use cutting or grinding wheels. Only use the recommended saw blades.
DISC INSTALLATION AND REPLACEMENT
• Remove the battery from the machine.
• Press and hold the rotation lock button # (17). Turn
the blade until the button clicks and the flange
stops rotating.
• Loosen the clamping screw # (11) by turning the
key to the left.
• Remove the clamping screw # (11) and the clamp-
ing flange # (10). Only remove the rear flange #
(10.1) to clean the machine and always make sure
that it is returned to the correct position.
• Slide the pivoting lower disc guard with handle #
(6.1) and hold.
• Make sure that the parameters of the saw blade
correspond to the machine (e.g. outer diameter,
thickness, maximum speed, hole diameter, type
(for wood, etc.)). Before inserting the saw, apply
a drop of oil to the flanges around the disc hole.
• Insert a new disc.
Note:
Insert the saw blade in the correct direction
so the rotation aligns with the arrow on the saw. The
teeth point upwards at the front of the saw.
• Reassemble the clamping flange and carefully
tighten screw # (11).
Note: This saw is not designed for cutting metal or
masonry. It is only to be used for cutting treated wood and similar materials.
PREPARING THE SAW