Commissioning
3-3
Configuring Basic Parameters
The
Basic Configuration
menu of the Monitor program includes all the
parameters necessary for the initial operation of BreezeACCESS SU-M-900.
In many installations, many of these parameters should not be changed
from their default values.
Configuration of parameters that affect the hopping frequencies and
hopping mechanism depends on the configuration of the relevant AUs.
NOTE:
YOU MUST PERFORM A SITE SURVEY AND SPECTRUM SWEEP PRIOR TO CONFIGURING
THE AU’S IN ORDER TO DETERMINE THE AVAIABLE CLEAR CHANNELS.
The following list includes the basic parameters and their default values:
Parameter
Default Value
Comment
IP Address
10.0.0.1
Subnet Mask
255.0.0.0
Default Gateway Address
0.0.0.0
DHCP Option
Disable
Access to DHCP
From Wlan Only
ESSID
ESSID1
Must be the same as the
ESSID the Base Station AU.
Transmit Antenna
Antenna
Hopping Channels
915 MHz
When HDM Mode in the AU
is enabled, configuring
these channels according to
site survey results will limit
the scan to these channels
only. If Scan Entire Band is
enabled (see below), then
this channel list will be
ignored.
If the roaming scan feature
is enabled, it is
recommended to configure
these channels according to
the deployment (see
Changes in HDM/Flexible
Hopping Definition
Parameters, on page 3-10).
Scrambling Mode
Enhanced
Not applicable when HDM
Mode in the AU is enabled.
