- 15 -
7
8. Ereasing the memory of the motor
This procedure is erasing the whole memory from the motor including limit positions, comfortable position and all remote controllers
After successful setup motor will do
the acoustic signal (x3 BIP)
and move UP and DOWN
Press the "P2" button
and you will hear an acoustic signal
(x1 BIP)
x1 BIP
Press the "P2" button
Press the "STOP" button
and you will hear an acoustic signal
(x1 BIP)
x1 BIP
Press the "P2" button
and you will hear an acoustic
signal (x1 BIP)
x1 BIP
Press the "STOP" button
and you will hear an acoustic
signal (x1 BIP)
x1 BIP
Press the DOWN" button
and you will hear an acoustic
signal (x1 BIP)
x1 BIP
If the mode I is active the motor performs
one
single slight movement in both directions.
If the mode II is active the motor performs
two
slight movements in both directions.
If the mode III is active the motor performs
three
slight movements in both directions.
In order to change the mode please repeat
the procedure.
OK
7. Selecting the mode of operation of the overload system
Mode I (average sensitivity - set at the factory) - the detection sensitivity is decreased by one rotation of the motor from the end position.
Mode II (the highest sensitivity) - the detection sensitivity decreased by 1/5 shaft rotation from the end position.
Mode III (the lowest sensitivity) - the detection sensitivity decreased over the entire working height.
6. The resistance and rebound function
After successful setup motor will do
the acoustic signal
(x2 BIP) if function is active,
(x1 BIP) if function is unactive.
To change the function please repeat
the procedure.
Press the "P2" button
and you will hear an acoustic
signal (x1 BIP)
x1 BIP
Press the "DOWN" button
and you will hear an acoustic
signal (x1 BIP)
x1 BIP
Press the "DOWN" button
and you will hear an acoustic
signal (x1 BIP)
x1 BIP
OK
