15
language:
English
model:
Netti III
Version:
February 2007
language:
English
model:
Netti III
Version:
February 2007
language:
English
model:
Netti III
Version:
February 2007
language:
English
model:
Netti III
Version:
February 2007
6.4 Front castors
To take of
• Press the release button under the front
fork.
To mount
• Lead the quick release axle into the
bearing house. Pull the fork slightly to
ensure that the fork is fully locked.
6.5 Seat height at the front
The seat height depends on:
• Size of front castors.
• Size of front fork.
• Check the angle of the castor bearing
house.
In chapter 5 there is several models of
both front castors and front forks to
choose between. For to change the
front castors or front fork - unfix the
wheel and place it in the required
position in the front fork.
angle of bearing house
Correctly adjusted angle of the front fork is
important to achieve proper manoeuvring
qualities of the wheelchair. Unfix the two
screws on the inside of the frame enough
to adjust the the eccentric nuts. Angle the
bearing house, so that it is 90
° relative to the
ground.
1 pc 5 mm allen key
The bearing house can not be adjusted
in height.
Check the position of the anti tip.
6.6 Seat height at the rear
The seat height at the rear depends on:
• Size of main wheel.
• Position of main wheel.
main wheel
Unfix the hub bushing, including washer and
nut, and mount it in required position in the
main wheel bracket.
2 pcs 24 mm open-end spanner
Summary of Contents for Netti III
Page 1: ...Netti III U S E R m a nu a l ...
Page 34: ...34 Language English Model Netti III Version February 2005 ...
Page 35: ...35 ...
