Alu_Rehab Netti III, User Manual

Page: 17 / 36

17
language: English model: Netti III Version: February 2007 language: English model: Netti III Version: February 2007 language: English model: Netti III Version: February 2007 language: English model: Netti III Version: February 2007
When using the comfort seat plate it
is recommended to change seat plate
when changing seat depth. The seat
plate comes in depth: 40 cm, 46 cm &
53cm. In seat width 35 cm & 38 cm it
only comes in depth 40 cm & 46 cm.
By using the adjustment straps in the
rear you can gain a few cm on the
depth.
Seat depth in the rear is adjusted as follows:
• Release the tilt gas strut by tilting the seat
all the way forward.
• Pull out the locking bolt for the back rest,
and place the back rest forward in the seat.
• Remove the screws holding the back rest
hinge, and set the back rest to the required
position. Do both sides at the same time.
• Place the screws back an fix them.
• Also remember to move the gas strut as
described earlier in this chapter.
6 mm allen key
13 mm open-end spanner
When changing seat depth, you also
change the tipping point of the chair. This
can be prevented by changing the
position of the main wheel in the main
wheel bracket. (See chapter 6.6).
6.9 adjusting seat depth at
the front
It is possible to adjust the seat depth up to
10 cm at the front. Do the following:
• Unfix the screw holding the pull out piece
for the foot support.
• Set the pull out piece to the required
position.
• Fix the screws.
6 mm allen key
By setting the pull out pieces to different
positions, it is possible to compensate
for a rotated pelvis or different length of
thighs.
6.10 anti tip
• Adjust the anti tip so that it doesn’t stick
outside the radius of the wheel.
• Pull the anti tip out / rearwards from chassis.
• Turn it down 180°.
• Lock it in position by moving forwards with
spring tension.