Altronic CD200D, Installation Instructions Manual

Page: 14 / 32

CD200D II 4-17 All rights reserved © ALTRONIC, LLC 2017
14
12.4 8 READ/WRITE CONFIGURATION BITS
SUPPORTS WRITE SINGLE ONLY
READABLE IN MULTIPLES OF 8 BITS
STARTING AT 8 BIT BOUNDARIES
ADDRESS FUNCTION
00001 DISK ON CAM=0 CRANK=1
00002 TEST FOR PROPER DISK YES=1
00003 ENABLE SECONDARY DIAGS YES=1
00004 ENERGY BIT0 00=~160 01=~170
00005 ENERGY BIT1 10=~180 11=~190
00006 SLAVE
00007 reserved
00008 OFF = MAGNETIC Pickup ON = HALL-EFFECT Pickup
12.5 4 READ/WRITE REGISTERS MIRROR COIL BITS
ADDRESS FUNCTION
40001 REG40001=CoilBits 00016-00001
40002 REG40002=CoilBits 00032-00017
40003 REG40003=CoilBits 00048-00033
40004 REG40004=CoilBits 00064-00049
12.6 8 READ/WRITE REGISTERS REGARDING APPLICATION
ADDRESS FUNCTION
40005 Disk+1 2,3,4,5,6,7,8,9,10,12
40006 Disk Lineup to TDC xx.x DEG
40007 Insertion Ret MIN=2.0 DEG xx.x
40008 Purge Delay Cycles 0-255
40009 RPM Over Speed Setpoint
40010 RPM Crank to Run Threshold
40011 Low Supply Voltage Limit xx.xV
40012 SLAVE ANGLE xx.x DEG
12.7 12 READ/WRITE REGISTERS FOR CYLINDER RET. TABLE
ADDRESS FUNCTION
40017 OUTPUT A EXTRA RETARD DEG
40018 OUTPUT B EXTRA RETARD DEG
40019 OUTPUT C EXTRA RETARD DEG
40020 OUTPUT D EXTRA RETARD DEG
40021 OUTPUT E EXTRA RETARD DEG
40022 OUTPUT F EXTRA RETARD DEG
40023 OUTPUT K EXTRA RETARD DEG
40024 OUTPUT L EXTRA RETARD DEG
40025 OUTPUT M EXTRA RETARD DEG
NOTE: Please see page 29 (Addendum)
for further details of 0XXXX Registers for
CD200D Unit - 791090-xR.
NOTE: Please see pages 29 through 31
(Addendum) for further details of 4XXXX
Registers for CD200D Unit - 791090-xR.