26
Roof Felting
Take the role of roof felt (grit side down) and roll it out somewhere flat e.g. a
garage floor. Also it is a good idea to have a sheet of ply or something similar
to slide under the felt to protect the floor when cutting.
Lay the single ply roof sheet onto the felt and mark out 50mm from the edge all the way
around it. Use a Stanley knife to cut this out. If you use a straight edge you will find this easier
and get a much neater cut.
Diagram 39
Diagram 40
Diagram 41
Once you have cut the first one use this as
your template. Be careful when moving it so
as not to damage it as you will want to use
this on the roof.
Just keep rotating the sheet until you have 6 felt sheets cut
ready to install. This ply panel can then be fitted to the
roof.
50mm
50
m
m
5
0
m
m
A
B0
15
0
9
