MULTITASKER™
400-0367-004
8
The Card ID is a unique identifier. It is equal to
the enclosure slot number, or it may be an
assigned value. As the slot number, the value
can range from 1 to 4 up to 1 to 20 depending
on the enclosure. If the value is assigned, the ID
may be a maximum of 99.
Card ID 0 (C0) is used for the controller and
cannot be reassigned.
The Group ID is a number representing a group
of cards defined with the [WR] command. When
using the Group ID, all cards in the group will
perform the given instruction.
Changing the position of a card will significantly
affect the commands recorded on software
definitions or third-party control systems.
The Unit ID has a value from 0 to 9. Unit ID 0
should be used for single unit operation. If the
Unit ID is set to zero, each command may be
used without Ui. Use the command, [SETU0],
as explained in the MT100-100 User’s Guide.
Example:
[VERC3]:
For Unit ID Zero
[VERC3Ui]: For Unit ID other than Zero
[VERC3]:
Equivalent to [VERC3U0]
1.
[C]
This command displays the active matrix
configuration settings.
Command Format: [CnUi]
Cn = Card ID (n = slot # from 1 to max slots)
Ui
= unit ID (i = # from 0 to 9)
Example:
There is an
MT107-103
in slot 5, sending the
command, [C5], will return feedback similar to
the following:
Matrix mode:non-blocking
Matrix number:1
Matrix size:64X64
Input offset:0
Output offset:0
Channel width:1
Channel space:0
Ch1 In1 Out1 ON AudioL32
Ch1 In1 Out2 ON AudioL32
…
Ch1 In64 Out64 ON AudioL32
Description of Feedback:
The first line shows the matrix in non-blocking
mode. The next line lists the matrix number,
1 to 9. The next five lines describe the
properties of the matrix. The remaining lines are
channel specific.
Matrix 1 is the active matrix. Matrix 1 is a 64X64
matrix with no input offset and no output offset.
The channel width is one and the channel
spacing is zero. All 64 channels are on, the
input audio level is set to the maximum of 32
and each input is
connected to its
corresponding output.
2.
[CLR]
This command resets the
MT107-103
to the last
saved matrix configuration. It does not effect the
blocking mode.
Command Format: [CLRCnUi]
Cn = Card ID (n = slot # from 1 to max slots)
Ui
= Unit ID (i = # from 0 to 9)
Example:
Clear the
MT107-103
with Engine Card in slot 5.
To do this, send the command [CLRC5].
