Altinex MT107-103, User Manual

Page: 17 / 28

MULTITASKER™
400-0367-004
16
27. [?C]
This command will return general information
about the card and its status. It is a function of
both the card and the front panel and is only
available with MultiTasker Front Panel systems
that have the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
NOTE: In MTSetup™, send the command
[VER] from the Terminal Window. The system
will respond with feedback similar to the
following:
[690-0122-015 690-0123-004 690-0124-018]
Check the last three digits against the numbers
above to determine if the option is available.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui
= Unit ID (i = from 0 to 9)
Example:
The MT107-103 in slot 5 has Input 1 connected
to all outputs. Outputs 1-4 are on and 5-64 are
off. Send the command [?C5] to receive the
feedback status.
The feedback is enclosed in brackets, “[ ]”, and
each data field is enclosed within parentheses,
“( )”. The first two characters indicated the
feedback type and the last three characters are
the card’s ID, (ex: C05).
See the [STA1] command for further details.
FEEDBACK DESCRIPTION
See Figure 1 for details on Matrix Configuration,
Connections and Input Volume.
[ = Begin Feedback
(MT107-103C05) = Model Number
(VR690-0159-006C05) = Firmware Version
(ME1646400000100C05) = Configuration
(MA010101…C05) = Connections 01-16
(MB010101…C05) = Connections 17-32
(MC010101…C05) = Connections 33-48
(MD010101…C05) = Connections 49-64
(ON111100…C05) = Output Status 01-32
(OL000000…C05) = Output Status 33-64
(VV0C05) = VIS (1=On, 0=Off)
(MM0C05) = Blocking (1=On, 0=Off)
(VA323232…32C05) = Input Volume 01-16
(VB323232…32C05 ) = Input Volume 17-32
(VC323232…32C05 ) = Input Volume 33-48
(VD323232…32C05 ) = Input Volume 49-64
] = End Feedback
NOTE: The VIS information applies to video
cards only.
28. [STA1]
This command enables automatic feedback
from the card and front panel. The command
affects any card with auto-feedback capability,
not just the
MT107-103 . The default at power on
or reset is STA0, OFF. The feedback is initiated
by a change in the card’s status or settings. This
type of feedback is an unsolicited response and
the feedback will be enclosed in parentheses,
“( )”.
Command Format: [STA1]