2.0
Installation, continued
2.6 Service Power Inserter (SPI-LPE)
To connect the coaxial cable
Before you remove the cover, unplug the SPI-LPE from the XM2-300HP.
1.
Remove the two screws holding the cover to the SPI-LPE chassis.
2.
Remove the SPI-LPE cover to expose the circuit board and seizure screw assembly.
3.
Insert the coaxial termination into the output port on the bottom of the SPI-LPE.
4.
Tighten the seizure screw to 35 inch-pounds.
5.
Fig. 2-4, Removing the Cover
2
3
1
Seizure Screw
Assembly
Fig. 2-5, Coaxial Cable Insertion and Securing
To prevent arcing, make certain the center conductor (stinger) of the coaxial termination is fully
seated inside the seizure screw assembly (5). Tighten to 35 inch-pounds.
CAUTION!
29
017-877-B1-001 Rev. A
