PRIma Gate
22
There are 3 different credits. You can set each of them.
o
Credit to restore
Set amount of credit (tariff) in
minutes, which is restoring. If this
credit is spent the outgoing call
via E1-line which used this credit
can be blocked (if you set Block
outgoing call when credit is spent)
or it will be routed to GSM
network according to CLIP Table and Routing Table. Max value of credit is 44640 min
(one month). Credit without limit is signified "0". You can see it in pane of Diagnostics
(E1_Credit).
o
Maximal remaining credit
Set amount of remaining minutes, which you have not spend yet, these will be rolled over
to the next month and added to your credit.
o
First count (in seconds)
First count (in seconds)
o
Next count (in seconds)
Length of the next period (1 to 250 seconds)
Parameters First count and Next count are used for account of the real length of the call
from the view of the carrier.
Example 1: If the call is charged per second - set both parameters to 1.
Example 2: If you are charged immediately after answering a call for the whole first
minute and then second by second - set first count to 60 and next count to 1.
Proper setting of these parameters helps you to keep real record of the minutes spent and
charged for each E1-line.
o
Block outgoing call when credit is spent. Outgoing call is default blocked when credit is
spent. The next outgoing call will be routed to GSM network according to CLIP Table and
Routing Table.
Expert Settings
This pane contains other parameters of lines. This
setting is not recommended to change.
-
L1 Parameters
Parameters for L1 layer.
Long Haul
This setting is not recommended to change (only the
Gateway is placed far away from PBX approximately
300m and PBX takes part of it).
-
RJ45 pin setting
You can choose from 3 options of RJ45 pin setting:
According to the protocol, Always TE or Always NT.
-
L2 Parameters
This setting is not recommended to change.
TEI selection (0-127)
Gateway identification address (0 by default, 127 max.)