Alpha Technologies GSM-VarioBell, User Manual

Page: 26 / 65

25
2. Switch ON GSM-VB
Switch on the unit only after you have connected all required
wires (relays, locks, etc.) Be careful when connection the
antenna. Only at the end connect the power supply adapter.
The red LED will light up and after a few seconds, the yellow
LED will start flashing (see table LED signaling on page 61).
The GSM-VB will announce initialization and SIM card reading
by tones or eventually by voice signaling, logging into the GSM
network and readiness for operation (see tones table on page
60).
When you have preprogrammed the SIM card, you can try the
first connection
– press a button. The GSM-VB must dial the
programmed number which has been assigned to a specific
button. When the SIM card is not programmed, first of all
program it (via later described methods) and only then try a
connection (the buttons do not have any assigned, any
programmed numbers
– that means the GSM-VB cannot call
anywhere). After establishing a call, you can adjust the
speaker
´s loudness. Close the cover and assemble the unit.
3. program the GSM-VB parameters
You can program in switch on GSM-VB parameters by 2 ways.
With SMS text messages or with a configuration program via a
USB port of your Windows computer.
A) Parameters setting by SMS.