AM-1600 Upgrade: Hardware Installation
Page 47
Eagle 450 Upgrade Instructions, Rev. A00
7.
If the computer contains a floppy controller, remove it and the diskette drive. Only SCSI diskette
drives are supported with the Eagle 450.
PREPARING THE AM-138 BOARD
1.
Use eight of the mounting screws you just removed to attach the AM-138 to the mounting plate.
2.
If you haven’t yet, check the jumpers on the AM-138 board to make sure they are set correctly.
Refer to the table in Chapter 4.
3.
Install the cache SIMM (DWB-00701-00) at location J12, following the instructions in Chapter
3.
4.
Install one or two memory SIMMs at J10 (and J11), following the instructions in Chapter 3.
INSTALLING THE NEW REAR PANEL AND AM-138
1.
Remove the four screws attaching the fan to the back panel and the back of the chassis. Save the
screws.
2.
Remove the five screws attaching the rear panel to the chassis, as shown in Figure 8-4. Save
these screws, also.