Eagle 300/500 Upgrade: Hardware Installation
Page 35
Eagle 450 Upgrade Instructions, Rev. A00
Removing a Horizontally-mounted Roadrunner
The Roadrunner is attached to a screen on the bottom of the chassis using four male/female standoffs and
four 6-32 Phillips-head screws. To remove it:
1.
Unplug all cables from the Roadrunner board, including the SCSI cable, power cable, X-bus
cables, etc.
2.
Unscrew the four Phillips-head screws holding the Roadrunner to the standoffs and lift the board
out.
3.
Unscrew the standoffs from the screen on the chassis bottom. They aren’t needed in the Eagle
450.
In this configuration, the Roadrunner board is
mounted on top of four standoffs which are
attached directly to the screen on the bottom
of the chassis.
6-32 PHILLIPS-HEAD
SCREW
Figure 7-4: Roadrunner Removal, Late-model Eagles
